Bedienungsanleitung Snooper S3 (Seite 9 von 14) (Englisch)

619690

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Installation S3

Once you have performed a download it is time to install the Snooper S3

into your vehicle. The most important aspects of this installation are

ensuring that the Snooper S3 is positioned in such a way that it has a

clear view of the sky whilst ensuring that the device is situated so that it

does not interfere with the vehicles controls and does not jeopardise

either the passengers or drivers safety.

For best results mount the S3 on to the vehicles dashboard so that the

top of the unit has a clear view of the sky. Some vehicles including

Renault’s, Citroens and Peugeot’s may come with a ’Heat reflective’ or

’Comfort’ front windscreen which may effect the performance of the

built-in GPS antenna, although the S3 will work effectively in vehicles with

a ’heated’ windscreen. In these situations you will need to purchase a

re-radiating antenna which can be positioned on the rear parcel shelf.

Contact Performance Products or your local dealer for further information.

In both cases the unit or extension antenna should be positioned so that

it has a clear view of the sky directly above. When positioning your

Snooper S3 ensure that it is located in such a way that you can easily

view the LED display without having to take your eyes from the road

ahead and so that you can reach the controls safely. Please also be

aware that you will need to be able to remove the device to perform

downloads. Once you have found a suitable location for your S3 secure it

in place with the ’Hook and loop’ fastener or suction cup bracket

provided, remembering to clean the area where the fastener or bracket is

going to be positioned thoroughly before hand to ensure a good contact.

More in depth mounting instructions are provided below.

PLEASE NOTE: Be careful to choose a location that does not block the

drivers view or where it might endanger the driver or passengers should

your vehicle suddenly come to a stop or be involved in an accident.

RS232

Windscreen

Dashboard

Radar Alerts (Only applicable where S100 RLD is connected)

If you have the S100-RLD connected to your S3 you will be able to

receive radar alerts. The information provided is more basic than when

you receive an alert via GPS but still effective. When the device first

receives a radar alert the unit will begin to ’Beep’ slowly at first but

quicken as you get closer to the source. At the same time the LED

display will indicate that you are detecting radar by illuminating the letter

’R’ on the display. Next the red LED’s will illuminate starting with a single

LED and building up to 4 red LED’s as you get closer to the source of the

radar.

Laser Alerts

The S3 incorporates a built-in laser detector. As laser often requires

instant action the device simply gives you a loud audible alert whilst the

display will flash ’L’ and all 4 red LED’s simultaneously. No signal strength

will be indicated.

If you would like to Mute either a Radar or Laser alert, simply press the

’Mute’ button at any time during the alarm.

CANCEL

NEW LOCATION

MUTE

CANCEL

NEW LOCATION

MUTE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Snooper S3 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info