680825
63
Zoom out
Zoom in
Vorherige Seite
1/96
Nächste Seite
63
S10564-00001_Rev-A_EN
11. Connections and special functions of the wall
control unit
11.5 Multi-function relay - MUFU 1
The MUFU 1 multi-function relay can be used for various
functions, such as additional exterior lighting or a door
status display. In delivery condition from the factory, the
multi-function relays outputs a pulse of 1 second every
time the motor starts.
INFORMATION
The functions of the multi-function relay
can be changed by SOMlink, a WLAN-
enabled device and a Memo tiga.
10 additional congurations are available
for the multi-function relay.
Time can also be set for timer operation.
Multi-function relay 1 - MUFU 1
ON
123
MUFU 1
Fig. LED for MUFU 1 Fig. MUFU 1
The status LED for MUFU 1 lights up green when the
relay is energised.
NOTE
Multi-function relay 1 contact is a potential-
neutral changeover contact and may only
be loaded with max. 250 V AC, 5 A or max.
24 V DC, 5 A.
The "Pulse for 1 second when starting motor" function is
set at the factory:
Multi-function relay 1 outputs a pulse of 1 second
every time the motor starts.
11.6 Relay
An additional multi-function relay can be attached at the
Relay slot. Additional functions can be activated, e.g.
exterior lighting or the door status display. The relay is an
optional accessory.
INFORMATION
The functions of the multi-function relay
can be changed by SOMlink, a WLAN-
enabled device and a Memo tiga.
10 additional congurations are available
for the multi-function relay.
Time can also be set for timer operation.
1
4
1
3
3
4
S1
Fig. Relay slot
NOTE
The relay contact is a potential-neutral
changeover contact and may only be
loaded with max. 250 V AC, 5 A or max.
24 V DC, 5 A.
The following function is activated at the factory.
The relay activates for 1 second when the operator
starts.
11.7 Photo eye and frame photo eye
Alternatively a 2-wire photo eye from SOMMER
Antriebs- und Funktechnik GmbH or a 4-wire photo
eye can be connected to the control unit. During
commissioning, the control system automatically detects
which version it is and sets itself to that version.
INFORMATION
If a photo eye is connected for door CLOSE
and detected by the control unit, the
close function is automatically activated.
The position of DIP switch 1 on the carriage
is independent of this.
INFORMATION
If a photo eye is retrotted on a
programmed system, the control
system must be reset, see Chapter
"10.13 Resetting the control unit".
INFORMATION
During commissioning of the photo eye
or the frame photo eye, it must not be
triggered by persons or objects.
63

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sommer S 9060 Tiga wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sommer S 9060 Tiga

Sommer S 9060 Tiga Bedienungsanleitung - Deutsch - 96 seiten

Sommer S 9060 Tiga Bedienungsanleitung - Holländisch - 96 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info