680825
64
Zoom out
Zoom in
Vorherige Seite
1/96
Nächste Seite
64
S10564-00001_Rev-A_EN
11. Connections and special functions of the wall
control unit
INFORMATION
If a photo eye is used as a frame photo eye
on the door, move the door to the centre
position.
2-wire photo eye for door CLOSE (PHOTO 1)
TX
24 V
24 V
Sign
al
GND
GND
COM
RX
PHOTO 1
TX
2
4
V
2
4
V
GND
G
N
D
RX
P
HOTO 1
Fig. Terminal for 2-wire photo eye
Connect the 1- or 2-wire photo eye to the PHOTO 1
terminal block. The polarity is optional. The status LED
(PHOTO 1) for door CLOSE lights up orange when the
safety device has been detected by the control unit.
Terminal block Function
Signal 2-wire photo eye,
any polarity
COM
The 2-wire photo eye (PHOTO 1) is interrupted in the
door CLOSE direction:
Status LED ashes orange during the interruption.
The operator stops gently and opens the door
completely.
The door closes automatically after the open
holding and clearing time.
4-wire photo eye for door CLOSE (PHOTO 1)
TX
24 V
24 V
Signa
l
GND
GND
COM
RX
T
Y
PHOTO 1
IN
Fig. Terminal for 4-wire photo eye
Connect the 4-wire photo eye to the terminal block for
door CLOSE (PHOTO 1). The supply for RX (Receiver)
should be on the side facing away from the sun.
The status LED (PHOTO 1) for door CLOSE lights up
orange when the safety device has been detected by the
control unit.
Terminal
block
Function
TX (Trans-
ceiver)
+24 V DC
Power supply
GND
RX
(receiver)
+24 V DC
GND
SIGNAL Potential-free relay
contact
COM
The photo eye (PHOTO 1) is interrupted in the door
CLOSE direction:
Status LED ashes orange during the interruption.
The operator stops gently and opens the door
completely.
The door closes automatically after the open
holding and clearing time.
Use as frame photo eye
1. Install the frame photo eye in the frame, see separate
"Frame photo eye" installation instructions.
2. Align the frame photo eye and connect to the wall
control unit.
3. Commissioning is performed as described in Chapter
"9. Commissioning".
If the door passes the frame photo eye, the
illumination power of the operator lighting is
reduced.
If the illumination power is not reduced, the frame
photo eye must be realigned and the control unit
must be reset.
During commissioning, the operator learns the
exact position of the frame photo eye in order to
blank it out in normal mode shortly before reaching
the door.
4. Check the frame photo eye function.Repeat the
process if necessary.
64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sommer S 9060 Tiga wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sommer S 9060 Tiga

Sommer S 9060 Tiga Bedienungsanleitung - Deutsch - 96 seiten

Sommer S 9060 Tiga Bedienungsanleitung - Holländisch - 96 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info