Bedienungsanleitung Sony DSC-S1900 (Seite 11 von 120) (Deutsch)

527782

Zoom out

Zoom in

Vorherige Seite

1/120

Nächste Seite

NederlandsPortuguêsEspañolItalianoFrançaisDeutschEnglish

Panel Descriptions

GA-FC jack

CUBE-40GX/80GX

only

You can connect the separately sold Roland GA-FC to switch

channels and turn eects on/o.

Connecting the GA foot controller (GA-FC; sold separately)

Connect a stereo cable to the FOOT SW GA-FC jack of the

CUBE-40GX/CUBE-80GX.

* Always use a stereo cable.

* Use cables that do not contain resistors.

GA-FC

Using the GA-FC

You can use the GA-FC to switch between JC CLEAN, LEAD, and

SOLO (MEMORY). You can also switch EFX, DELAY, and REVERB on/

o.

Ax the included adhesive labels to the GA-FC.

Switch Explanation

JC CLEAN Selects the JC CLEAN channel.

LEAD Selects the LEAD channel.

SOLO Selects the SOLO channel.

EFX Turns EFX on/o.

DELAY Turns DELAY on/o.

REVERB Turns REVERB on/o.

* Once you’ve turned o EFX, DELAY, or REVERB from the GA-FC, you

must rst turn the corresponding knob to the OFF position in order

for the [EFX], [DELAY], or [REVERB] knobs of the amp itself to be

re-enabled.

Using the expression pedals

By connecting expression pedals (Roland EV-5, BOSS FV-500L, BOSS

FV-500H; sold separately), you can change the input volume and

master volume by pedal.

GA-FC

Expression pedals

Jack Explanation

INPUT VOL

Adjusts the input volume.

* The input volume that is controlled by the expression

pedal connected to this jack cannot be adjusted from

the panel.

MASTER VOL

Adjusts the master volume. This lets you use volume

changes as a performance technique, or to mute your

instrument.

* The master volume that is controlled by the expres-

sion pedal connected to this jack is dierent than that

of the [MASTER] knob on the panel.

Setting MINIMUM VOLUME of an expression pedal

With the [MINIMUM VOLUME]

knob of an expression pedal,

you can set the value for when

the pedal is lifted up all the way

(lowest value).

* Use only the specied expression pedal (Roland EV-5, BOSS FV-500L,

BOSS FV-500H; sold separately). By connecting any other expression

pedals, you risk causing malfunction and/or damage to the unit.

Memory/FC priority mode

(EFX, DELAY, REVERB on/o)

You can specify how EFX, DELAY, and REVERB will operate when you

switch the channel.

* The changed setting will be remembered even if you turn o the

power.

Memory priority mode (factory setting)

When you select SOLO, the stored on/o settings will take priority.

To make this setting

Turn on the power while holding down the CUBE’s [JC CLEAN]

button.

* Hold down the button until all LEDs blink.

FC priority mode

The on/o statuses of the GA-FC will always take priority when you

switch channels.

To make this setting

Turn on the power while holding down the CUBE’s [LEAD]

button.

* Hold down the button until all LEDs blink.

[MINIMUM

VOLUME]

knob

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony DSC-S1900 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony DSC-S1900

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info