Bedienungsanleitung Sony STR-DN1080 (Seite 57 von 72) (Englisch)

699403

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Additional Information

Cannot connect to the network using WPS

via a wireless LAN connection.

You cannot connect to a network using [Wi-Fi

Protected Setup

(WPS)] if your access point

is set to WEP. Set up your network after

searching the access point using the access

point scan.

Cannot connect to the network.

 Check that the LAN cable is connected to

the receiver when you want to connect the

receiver to the network via a wired LAN

connection.

 Check the network information. If the

connection failed, set up the network

connection again.

 If the receiver is connected through a

wireless network, move the receiver and

the wireless LAN router/access point closer

to each other and perform the setup again.

 Make sure that you use a wireless LAN

router/access point.

 Make sure that the wireless LAN router/

access point is turned on.

 Check the settings of the wireless LAN

router/access point and perform the

setup again. For details on the settings of

devices, refer to the operating

instructions of the devices.

 Wireless networks are influenced by

electromagnetic radiation emitted by

microwave ovens and other devices.

Move the receiver away from these

devices.

Cannot select the [Network Settings] menu.

Wait for a few moments after you have

turned on the receiver, and then select the

[Network Settings] menu again.

"PROTECTOR" appears on the display panel.

The receiver will automatically turn off after a

few seconds. Check the followings:

 There may be an electrical surge or power

failure. Unplug the AC power cord (mains

lead) and then plug in the cord again after

30 minutes.

 The receiver is covered and the ventilation

holes are blocked. Remove the object

covering the ventilation holes of the

receiver.

 The impedance of the connected speakers

is below the rated impedance range

indicated on the back panel of the receiver.

Reduce the volume level.

 Unplug the AC power cord (mains lead) and

let the receiver cool down for 30 minutes

while performing the following

troubleshooting:

 Disconnect all of the speakers and

subwoofer.

 Check that the speaker wires are tightly

twisted on both ends.

 Connect the front speaker first, increase

the volume level and operate the receiver

for at least 30 minutes until it completely

warms up. Then, connect each additional

speaker one by one and test each

additional speaker until you detect which

speaker is causing the protection error.

After checking the above items and fixing

any problems, plug in the AC power cord

(mains lead) and turn on the receiver. If the

problem persists, consult your nearest Sony

dealer.

[Overload occurred.] appears on the TV

screen.

An over-current from the  (USB) port was

detected. Disconnect the USB device as

prompted in the warning message and close

the message.

Code 30

Headphones are connected. Please

disconnect the headphones and retry

calibration.

Code 31

The front speakers are not selected correctly.

Select the front speakers correctly using

SPEAKERS on the receiver and perform Auto

Calibration again while sound is being

output. For details on selecting the front

speakers, see “Selecting the front speakers”

(page 41).

Network connection

Error messages

List of messages after Auto

Calibration measurements

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony STR-DN1080 Seite 57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony STR-DN1080

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info