812337
58
Zoom out
Zoom in
Vorherige Seite
1/64
Nächste Seite
Error Messages
The relay is switched on if one or several of the set protective functions are activated. This function can be inverted so that the relay is turned
on (Duration on) and then turned off again if a protective function is activated.
Error message
Activate or deactivate function
The additional function error message activates the relay for certain events and only deactivates again when the information message to
each event was read.
The following messages are available:
Collector protection
System protection
Frost Protection
Recooling
Anti Legionella
Message
Sensor error VFS1
Sensor error VFS2
Pressure monitor
In this menu, the system pressure monitoring can be activated through a direct sensor. As soon as the set pressure conditions are undershot
or exceeded, the set relay will switch on.
Pressure monitor
Relay turns on if the pressure goes below the minimum or exceeds the maximum.
RPS-Type
Type of pressure sensor
In this menu, you can adjust which pressure sensor is being used. Please note: If e.g. VFS1 is connected, RPS1 option is not shown.
RPS Max
Maximum pressure in the system. If this pressure is exceeded, the controller emits an error notification and the relay switches.
RPS Min
Minimum pressure. If this pressure is not met, the controller emits an error notification and the relay switches.
Dehumidifier
Operating mode
The operating mode of the dehumidifier function can be set here.
Cooling : In the cooling operating mode, the dehumidifier turns on when the target humidity is exceeded, if the S/W day temperature is
exceeded and the function is approved.
Cooling +Circ.: In the cooling +circulation operating mode, the dehumidifier turns on when the target humidity is exceeded, if the S/W day
temperature is exceeded and the heating circuit pump is running and the function is approved.
Year round: In the year round operating mode, the dehumidifier turns on when the target humidity is exceeded if the function is approved.
Reference humidity
Reference value for the humidity in the room.
If the value set here is exceeded, the relay will turn on the dehumidifier if this is approved for the time. The dehumidifier is turned off if the ref-
erence value hysteresis is not met.
Hysteresis
Hysteresis of setpoint for the humidity.
58
58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sorel LHCC 24V wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sorel LHCC 24V

Sorel LHCC 24V Bedienungsanleitung - Deutsch - 65 seiten

Sorel LHCC 24V Bedienungsanleitung - Französisch - 64 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info