812372
19
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
Recooling
In the system hydraulics with solar, excess energy is guided from the storage back to the collector with an activated return cooling function.
This only occurs if the temperature in the storage is greater than the value “Return cooling Tref” and the collector is at least 20 °C colder
than the storage and until the storage temperature has fallen below the value “Return cooling Tref”. For muti-storage systems, the return
cooling applies to all storage.
Energy is lost through the collector through this function! The recooling should only be activated in cases of exception, with low
heat acceptance, for example, during vacation.
Anti-Legionella
The anti-legionella function is an additional function for certain relay functions such as: electric heating rod, burner, circulation,
compressor.
With the help of the anti legionella function (hereinafter referred to as: AL), the system can be heated up at selected times in order to free it
of legionella.
In the delivery state, the anti legionella function is switched off.
Antilegionella function is not shown in the menu “Protective functions”. It is instead shown as submenu of the corresponding
special function. Special functions with AL include: Solar, burner, circulation and compressor.
As soon as it has heated up with “AL” turned on, information with the date will be shown in the display.
This anti legionella function does not offer any secure protection against legionella, because the controller requires an
adequate added amount of energy and the temperatures cannot be monitored in the entire storage area and the connected
pipe system.
During the operation of the anti legionella function, if applicable, the storage is heated above the set value “Tmax”, which may
lead to scalding and system damage.
7. Special Functions
Used to set basic items and expanded functions.
The settings in this menu should only be changed by a specialist.
Program selection
Here the hydraulic variation fitting to the respective use case is selected and set.
The program selection normally occurs only once during the first entry into service by a specialist. An incorrect program selec-
tion may lead to unpredictable errors.
Signal
In this menu, the preset profiles for the signal can be selected or under “manual” all settings can be done personally. The settings can still
be changed after a profile has been selected.
19
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sorel STDC wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sorel STDC

Sorel STDC Bedienungsanleitung - Deutsch - 26 seiten

Sorel STDC Bedienungsanleitung - Holländisch - 48 seiten

Sorel STDC Bedienungsanleitung - Französisch - 48 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info