Bedienungsanleitung Soundmaster NR540 (Seite 17 von 87) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Schwedisch, Norwegisch)

733816

Zoom out

Zoom in

Vorherige Seite

1/87

Nächste Seite

M_NR540

English

Instruction Manual

Phono

1. operation

- Remove the stylus protector.

- Be sure that the tone arm is being detached from the tone

arm rest before operating and re-secured again afterwards.

1. Select to “Phono” function by pressing Phono/Aux button (24)

2. Set the speed selector (29) to the proper position depending on the record to be played.

3. Place the record on the platter (use the spindle adaptor (26) if required).

4. Set the Tone arm lever (28) to the up position.

5. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate and position the tone arm over

the desired position of the record.

6. Pull down the Tone arm lever (28). The tone arm will come slowly on the recorder and start playback.

7. At the end of record, the tone arm will return to the rest position automatically.

8. To stop manually, lift the tone arm from the record and return it to the rest.

 Play suspension

Set the cueing lever (28) to the up position will life up the tone arm and then stop playback temporarily

Remark:

- Due to the auto return system was mechanical design and reset point will be affected after transportation.

Thus, the tone arm will return to the rest automatically when first time place it to the platter and it was not

the malfunction

- Due to the length of the record is various, if you find the tone arm cannot return automatically after

playback of record. Please return the tone arm back to the rest position manually or adjust the auto return

point as below procedure.

Important:

To make sure the turntable can play the record with different standard completely, a hole with “NO OPEN” PVC plate located at the

back of the unit (33) to adjust the screw inside the turntable.

When the turntable stop early and the auto-return, pls use a screw driver to turn the screw inside the hole about 45 degree in

clockwise direction, if the record still can not be played completely, stop play and re-turn the screw 45 degree in clockwise direction

again, till the turntable can be play the record completely and auto return.

When the turntable can not be stop and auto return but keep running after playing the record completely, pls use a screw driver to

turn the screw inside the hole about 45 degree in counter-clockwise direction, if the record still can not be played completely, stop

play and re-turn the screw 45 degree in counter-clockwise direction again, till the turntable can be play the record completely and

auto return.

Remark: Due to Phono and Aux design in same channel of this unit, once the Aux in jack (2) plugged by any 3.5mm stereo plug, the

Phono function will change to Aux in automatically and the turntable will stop to spin. Made sure the Aux In jack (2) is not plugged by

anything before playing phono.

Stylus assembly

Cartridge

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Soundmaster NR540 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info