Bedienungsanleitung Sparky BP 330E (Seite 10 von 110) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

604122

Zoom out

Zoom in

Vorherige Seite

1/110

Nächste Seite

BP 330E

SELECTING THE OPERATION MODE

The switching of operation modes can be per-

formed when the machine is not operating.

Rotate the operation mode switch 4 in the direc-

tion marked on the switch to the desired position

to choose:

(1) Impact drilling (Fig.6) - for drilling masonry,

concrete, etc.

(2) Hammer mode (Fig.7) - for chiselling and

demoliting.

(3) Adjusting the chisel position (Fig.8) to x

the chisel in the desired angular position for

demoliting and chiselling (see “Adjusting the

chisel position”).

WARNING: Turn the operation mode

selector switch only in the direction marked

on the switch. During each switching between

operation modes turn the tool slightly by hand

leftwise and rightwise until it is locked.

In impact drilling mode the rotary hammer

equipped with adapter and chuck 176838 (not

included) can be used as a drill for drilling in

steel, wood, plastics, etc.

ADJUSTING THE CHISEL POSITION

(Fig.9)

- Insert the tool into the socket as it is described

in section “Inserting the SDS-Plus tool”.

- Turn the operating mode switch 4 in position

“Adjusting the chisel position”.

- Rotate the tool by hand to the desired posi-

tion.

- Turn the operating mode switch 4 to position

“hammer”, and then turn the tool slightly by hand

leftwise and rightwise until it is locked.

Longer operation life of the rotary hammer and

higher efciency can be achieved only with well-

sharpened tools for demoliting and chiselling.

AUXILIARY HANDLE

Always use the auxiliary handle.

Loosen the handle by turning it leftwise. Turn the

handle in the most convenient for operation po-

sition, and then tighten it well.

Do not carry the machine by a loose auxiliary

handle.

You can x the drilling depth through depth

gauge 8. The depth gauge 8 can be xed by

screw 9.

RECOMMENDATIONS FOR

OPERATION

Apply moderate pressure during operation (ap-

proximately 50-80 N)! Higher pressure will not

increase efciency when drilling and chiselling,

but it will lead to decreasing the operation life of

the machine.

Take the drill bit out of the opening from time to

time to remove dust.

Watch out for the stage of bit blunting and re-

place the bit when considerable decrease of ef-

ciency is observed.

The optimum capacity when drilling in concrete

is up to 24 mm, and the possible capacity is up

to 30 mm.

ACCESSORIES

▪ SDS-Plus drill bits for concrete Ø6 mm to

Ø24 mm;

▪ SDS-Plus core cutters up to Ø80 mm;

▪ SDS-Plus point chisels up to 300 mm long;

▪ SDS-Plus at chisels up to 40 mm wide.

WARNING: We recommend using

these accessories or attachments when op-

erating your power tool. The use of any other

accessories or attachments might present a

risk of injury. Only use accessory or attach-

ment for its stated purpose. If you need any

assistance for more details regarding these

accessories, ask your local SPARKY service

centre.

VII - Maintenance

WARNING: Always ensure that the

tool is switched off and unplugged before

attempting to perform inspection or mainte-

nance.

GENERAL INSPECTION

Regularly inspect all fasteners and ensure they

are properly tightened. Should any of the screws

be loose, retighten it immediately to avoid haz-

ards. (Fig. 10)

If the replacement of the supply cord is neces-

sary, this has to be done by the manufacturer or

his agent in order to avoid a safety hazard.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sparky BP 330E Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info