Bedienungsanleitung Sparky BP 750CE (Seite 11 von 114) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

604120

Zoom out

Zoom in

Vorherige Seite

1/114

Nächste Seite

Original instructions

GENERAL INSPECTION

Regularly inspect all fasteners and ensure they

are properly tightened. Should any of the screws

be loose, retighten it immediately to avoid haz-

ards.

If the replacement of the supply cord is neces-

sary, this has to be done by the manufacturer or

his agent in order to avoid a safety hazard.

CLEANING

For safe operation always keep the machine

and its ventilation slots clean.

Regularly check to see if any dust or foreign

matter has entered the ventilation slots and the

grills around the switches. Use a soft brush and/

or air jet to remove any accumulated dust. Wear

safety glasses to protect your eyes whilst clean-

ing.

Exterior plastic parts may be cleaned with a

damp cloth and mild detergent if necessary.

WARNING: Never use alcohol, petrol

or other cleaning agent. Never use caustic

agents to clean plastic parts.

WARNING: Water must never come

into contact with the tool.

IMPORTANT! To assure product safety and re-

liability, repairs, maintenance and adjustment

(including brush inspection and replacement)

should be performed by certied service centres

or other qualied service organisations, always

using genuine replacement parts.

BUILT-IN DUST PROTECTION

The protective ring 1 preserves the tool socket

from dirt during operation. While inserting the

tool, take care that you do not damage the pro-

tective ring.

WARNING: Replace a damaged pro-

tective ring immediately!

To replace the protective ring 1, pull back the

locking socket 2. Grasp the protective ring and

pull it strongly slantwise forward. Place a new

protective ring onto the spindle and press it

hard.

INDICATION “SERVICE MAINTE-

NANCE”

When the red light-emitting diode 10 begins to

blink while the machine operates normally, re-

placement of the brushes is needed. After ap-

proximately 8h operation, the brushes are worn

out completely and the safety switch actuates.

The machine halts and the red light-emitting di-

ode keeps blinking. Deliver the machine to an

authorised service for repla cement of brushes

and preventive main tenance.

If the machine does not operate before the

warning period of 8 hours is over, and the red

light-emitting diode 10 blinks, that probably

means the motor is damaged. In case there is

no light indication and the machine does not op-

erate, that means there is no power supply to

the machine or that the automatic switch or the

cord are faulty.

PREVENTIVE MAITENANCE

This power tool shall be submitted periodically

to SPARKY authorised service centre for pre-

ventive maintenance. Preventive checks will

boost the life of your power tool.

First check - after approximately 70 h ope-

ration.

The functioning of the machine shall be evalu-

ated and if necessary the machine shall be

checked.

Second check - after approximately 140 h op-

eration or upon the event of brushes wearing

out.

The machine shall be cleaned thoroughly and

checked. Ascertained or potential faults shall be

eliminated (brushes and O-ring sealings shall be

replaced).

Third check - after approximately 250 h opera-

tion or upon the event of brushes wearing out.

The machine shall be cleaned thoroughly and

checked. Ascertained or potential faults shall be

eliminated (brushes and O-ring sealings shall be

replaced).

Fourth check - after approximately 350 h oper-

ation or upon the event of brushes wearing out.

The machine shall be cleaned thoroughly and

checked. Ascertained or potential faults shall be

eliminated (brushes and O-ring sealing shall be

replaced).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sparky BP 750CE Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info