EMERGENCY STOP
SAFETY TETHER KEY
Before beginning a workout session ensure that the Safety Key is properly placed onto the
Computer Console and the Safety Clip is securely attached to an article of your clothing.
If you fall the clip will pull out the SAFETY KEY from the Computer Console and the running
belt will stop immediately for emergency stop, helping to prevent injury.
Replaced the Safety Key onto the Computer Console. Press the START button to
begin exercise again.
BELT ADJUSTMENT
The running belt is pre-adjusted to the running deck at the factory, but after prolonged use
it can stretch and require readjustment. To adjust the belt, turn on the main power switch
of the treadmill and let the belt run at a speed of 8-10 KPH. Use the Allen Wrench
provided to turn the rear roller adjustment bolts in order to centre the belt. If the running
belt is shifting to the left, turn the left adjustment bolt 1/4 turn clockwise, and the running
belt should start to correct itself.
Tool:
Allen Wrench
If the running belt is shifting to the right, then turn the right adjustment bolt 1/4 turn
clockwise, and the belt should start to correct itself. Keep turning the adjustment bolts until
the running belt is properly centered.
Tool:
Allen Wrench
If the running belt is slipping during use, turn off and unplug the treadmill. Using the Allen
Wrench provided, turn both left and right rear roller adjustment bolts 1/4 turn clockwise,
then turn the main power switch back on and run the treadmill at a speed of 8-10 KPH.
Run on to the running belt to determine if the belt is still slipping. Repeat this procedure
until the belt no longer slips.
Tool:
Allen Wrench
