Bedienungsanleitung Stanley FMCR001 (Seite 8 von 104) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

720673

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

ENGLISH

(Original instructions)

between 18 ° – 24 °C. DO NOT charge the battery pack in

an air temperature below +4.5 °C), or above +40 °C. This

is important and will prevent serious damage to the battery

pack.

u The charger and battery pack may become warm to the

touch while charging. This is a normal condition, and

does not indicate a problem. To facilitate the cooling of

the battery pack after use, avoid placing the charger or

battery pack in a warm environment such as in a metal

shed or an uninsulated trailer.

u If the battery pack does not charge properly:

u Check operation of receptacle by plugging in a lamp

or other appliance;

u Check to see if receptacle is connected to a light

switch which turns power off when you turn out

the lights;

u Move the charger and battery pack to a location

where the surrounding air temperature is

approximately 18 ° – 24 °C;

u If charging problems persist, take the tool, battery

pack and charger to your local service center.

u The battery pack should be recharged when it fails to

produce sufcient power on jobs which were easily

done previously. DO NOT CONTINUE to use under these

conditions. Follow the charging procedure. You may also

charge a partially used pack whenever you desire with no

adverse effect on the battery pack.

u Foreign materials of a conductive nature such as, but

not limited to, grinding dust, metal chips, steel wool,

aluminum foil, or any buildup of metallic particles

should be kept away from charger cavities. Unplug the

charger before attempting to clean.

u Do not freeze or immerse the charger in water or any

other liquid.

Tool placement (g. D)

Place the charger / radio on a smooth, level surface as shown

in Figure D.

On/Off - volume dial

u To operate as a corded product, insert the AC plug (10)

into an appropriate AC power outlet or generator.

u To operate as a cordless product, insert a fully charged

20v Max Stanley Fat Max battery (not included) into the

battery port (13) . Be sure battery is fully seated.

u To turn the radio ON, press the ON/OFF - be sure battery

is latched and fully seated.

u Press the ON/OFF - Volume dial again to turn the radio

OFF.

Volume adjustment

u Rotate the ON/OFF - Volume dial (1) clockwise to increase

the volume.

u To decrease the volume, rotate the ON/OFF - Volume dial

(1) counter clockwise.

Note: If the battery is attached to the radio and the AC plug is

plugged in at the same time, the radio will run off of the AC

power and not drain the battery. Having both attached

simultaneously will prompt the unit to charge the battery.

Mode function

To choose one of the mode functions (FM, AM, or AUX)

push the mode button (2) until the desired function is

displayed on the LCD. For example, if the radio is on FM,

push the mode button two times to change to AUX.

Note: The rst press on any buttons when the back light is

off, will wake the unit up. Press the desired button again to

activate the function.

Tune or seek function

To tune:

u Press and hold the right tune / seek button (8) to quickly

move the tuner up the frequency band. To move the

tuner down the frequency band, press the right tune/seek

button.

To seek:

u Press and hold the left tune/seek button (8) , then release

to quickly scan up the frequency band to the next available

station. Press and hold the bottom tune/seek button (2) ,

then release to quickly seek down the frequency band.

To program the clock

The clock can be programmed with the power ON.

u Press and hold the clock button (7) until the hour numbers

of the digital time ash on the LCD (5) , then release the

clock button.

u Rotate the ON/OFF-Volume dial (1) left or right to

tune/seek buttons (8) to set hour.

u When the correct hour is set, press the clock button

once so the minute numbers ash.

u Rotate the ON/OFF-Volume dial (1) left or right to

tune/seek buttons (8) to set minutes.

u If you do not press a button within 5 seconds, the clock

programming feature will automatically return to the

previous setting. The clock is set once the clock button

is re-pressed or if the numbers stop ashing.

To program the presets

6 FM and 6 AM radio stations may be independently set.

After programming the buttons, pressing the “1-6” preset

toggle button (4) will instantly change the frequency to the

preset station.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley FMCR001 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info