5
overhea t. In such event , compressor may automa tically shut down. T urn off the Compr essor Pow er Switch immediately and r estar t
SPECIFIC SAFET Y INSTRUCTIONS FOR JUMP ST ARTERS
WARNING: BURST HAZARD
Do not use the unit for charging dry- cell batt eries that are commonly used with home appliances . T hese batteries may burst and
supply power t o a low-voltage electrical system other than in a star ter-mot or application.
electrical shock and injur y to persons.
WARNING: RISK OF EXPL OSIVE GASES
For this r eason, it is of the utmost impor tance that each time befor e using the jump-star ter you r ead this manual and follow
manufacturer of any equipment y ou intend to use in the vicinity of the battery . Review cautionar y markings on these products
and on the engine.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERT Y DAMA GE:
awar e of first aid procedures in case of acciden tal contact with batter y acid .
battery can produce a short circuit current high enough to w eld a ring, or similar metal object, to skin, causing a sev ere burn.
electrical sparks.
clamps, cor ds, clothing and body parts away from mo ving vehicle par ts.
(BLACK) clamp t o the vehicle chassis or engine block away fr om the battery. Do not connect the clamp to the carbur etor , fuel
lines or sheet-metal body parts. Connect to a heavy gauge metal par t of the frame or engine block.
fuel lines or sheet-metal body parts. Connect to a heavy gauge metal par t of the frame or engine block.
and the unit will sound a beep . Disconnec t clamps and r econnec t to ba tter y with corr ec t polarity .
grounded systems .
heavy-dut y electrical tape to preven t shor ting (shorting c an r esult in injur y or fire).
system.
have a ba tter y installed.
attempts , discontinue jump-star t procedur es and look for other problems that may need t o be corrected.
4
W atch what y ou are doing. U se common sense. Do not operate appliance when y ou are tired .
Any part that is damaged should be replaced by the manufacturer befor e fur ther use. C ontact the
manufacturer at (877) 571-2391 for more inf ormation.
Motors in these tools
normally spark, and the sparks might ignite fumes.
disconnect the unit from any power sour ce before att empting maintenance or cleaning.
T urning off contr ols without disconnecting will not reduce this risk.
Therefor e, if used in a garage or
enclosed area, the unit MUST be placed not less than 18 inches abo ve the floor .
outlet.
SPECIFIC SAFET Y INSTRUCTIONS FOR CHARGING THIS UNIT
for a full 24 hours before using for the first time . Y ou cannot over charge the unit using the AC char ging method.
position before connection to a pow er source or load.
WARNING: SHOCK HAZARD
enough to carry the current your product will draw . An undersized cord will cause a dr op in line voltage resulting in loss of pow er
and overhea ting. The following table shows the c orrect size to use depending on cord length and namepla te ampere rating . If in
MINIMUM GA GE FOR CORD SET S
Volts T otal Length of Cord in F eet
(0-7.6m) (7.6-15.2m) (15.2-30.4m) (30.4-45.7m)
(0-15.2m) (15.2-30.4m) (30.4-60.9m) (60.9-91.4m)
More Not more
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 Not Recommended
mak e sure that:
c) the wir e size is large enough for the A C rating of the charger .
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERT Y DAMA GE: Pull cord by plug r ather than cord when disconnecting
SPECIFIC SAFET Y INSTRUCTIONS FOR COMPRESSORS
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERT Y DAMA GE: Never leav e the compressor unattended while in use .
WARNING: BURST HAZARD:
CAUTION: TO REDUCE THE RISK OF PROPERT Y DAMA GE:
J5C09_ManualENSP_031113.indd 4-5 3/11/2013 11:27:13 AM