Bedienungsanleitung Stanley SCD121 (Seite 7 von 64) (Englisch, Französisch, Türkisch)

720470

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

(Original Instructions) ENGLISH

ASSEMBLY

WARNING! Before assembly, remove the battery

from the tool.

Charging procedure (Fig. B)

• Plug the charger (10) into an appropriate outlet before

inserting battery pack.

• Insert the battery pack (7) into the charger. The charging

light will blink continuously indicating that the charging

process has started.

• The completion of charge will be indicated by the

charging light remaining ON continuously. The pack is

fully charged and may be used at this time or left in the

charger.

NOTE: To ensure maximum performance and life of Li-Ion

batteries, charge the battery pack fully before first use.

Charging Process

Refer the tables below for the state of charge of the battery

pack.

State of charge SC122

charging

green blink

fully charged

green light

hot/cold battery

damaged batter y

red blink

red ﬂash

Hot/Cold pack delay

The SC122 charger have a hot/cold delay feature. When

the charger detects a battery that is hot, it automatically

delays charging until the battery has cooled. When the

charger detects a battery that is cold, it automatically delays

charging until the battery has warmed. The red light will

continue to blink and can’t start to charging procedure. once

the battery has cooled, the charger will resume the charging

procedure.

Damaged battery

The charger can detect a weak or damaged battery. The

red LED flashes in the pattern indicated on the label. If you

see this damaged battery blink pattern, do not continue

to charge the battery. Return it to a service center or a

collection site for recycling.

Electronic protection system

STANLEY Li-Ion batteries are designed with an Electronic

Protection System that will protect the battery against

overloading, overheating or deep discharge.

The tool will automatically turn off if the Electronic Protection

System engages. If this occurs, place the Li-Ion battery on

the charger until it is fully charged.

Important safety instructions for all battery packs

When ordering replacement battery packs, be sure to

include catalog number and voltage.

The battery pack is not fully charged out of the carton.

Before using the battery pack and charger, read the safety

instructions below. Then follow charging procedures

outlined.

Read all instructions

• Do not charge or use battery in explosive

atmospheres, such as in the presence of flammable

liquids, gases or dust. Inserting or removing the

battery from the charger may ignite the dust or fumes.

• Never force battery pack into charger. Do not

modify battery pack in any way to fit into a non-

compatible charger as battery pack may rupture

causing serious personal injury.

• Charge the battery packs only in STANLEY chargers.

• DO NOT splash or immerse in water or other liquids.

• Do not store or use the tool and battery pack in

locations where the temperature may reach or

exceed 40 ˚C (105 ˚F) (such as outside sheds or

metal buildings in summer).

WARNING: Never attempt to open the battery

pack for any reason. If battery pack case is

cracked or damaged, do not insert into charger.

Do not crush, drop or damage battery pack. Do not use

a battery pack or charger that has received a sharp blow,

been dropped, run over or damaged in any way (i.e.,

pierced with a nail, hit with a hammer, stepped on). Electric

shock or electrocution may result. Damaged battery packs

should be returned to service centre for recycling.

CAUTION: When not in use, place tool on its

side on a stable surface where it will not cause

a tripping or falling hazard. Some tools with large

battery packs will stand upright on the battery pack but may

be easily knocked over.

Specific safety instructions for lithium ion (LI-Ion)

• Do not incinerate the battery pack even if it is

severely damaged or is completely worn out. The

battery pack can explode in a fire. Toxic fumes and

materials are created when lithium ion battery packs

are burned.

• If battery contents come into contact with the skin,

immediately wash area with mild soap and water.

If battery liquid gets into the eye, rinse water over the

open eye for 15 minutes or until irritation ceases. If

medical attention is needed, the battery electrolyte is

composed of a mixture of liquid organic carbonates and

lithium salts.

Liquid organic carbonates and lithium salts.

• Contents of opened battery cells may cause

respiratory irritation. Provide fresh air. If symptoms

persists, seek medical attention.

WARNING: Burn hazard. Battery liquid may be

flammable if exposed to spark or flame.

Transportation

STANLEY batteries comply with all applicable shipping

regulations as prescribed by industry and legal standards

which include UN Recommendations on the Transport of

Dangerous Goods; International Air Transport Association

(IATA) Dangerous Goods Regulations, International

Maritime Dangerous Goods (IMDG) Regulations, and

the European Agreement Concerning The International

Carriage of Dangerous Goods by Road (ADR). Lithium-

ion cells and batteries have been tested to section 38.3 of

the UN Recommendations on the Transport of Dangerous

Goods Manual of Tests and Criteria. In most instances,

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SCD121 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info