Bedienungsanleitung Stanley SCS4 (Seite 6 von 31) (Englisch, Französisch)

720799

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

ENGLISH (Original Instructions)

by foreign material. Foreign materials of a conductive

nature such as, but not limited to, grinding dust, metal

chips, steel wool, aluminum foil, or any buildup of metallic

particles should be kept away from charger cavities. Always

unplug the charger from the power supply when there is

no battery in the cavity. Unplug charger before attempting

to clean.

♦ DO NOT attempt to charge the battery with any

chargers other than the ones in this manual. The

charger and battery are specifically designed to work

together.

♦ DO NOT attempt to charge the battery with any

chargers other than the ones in this manual. The

charger and battery are specifically designed to work

together.

♦ These chargers are not intended for any uses other

than charging STANLEY rechargeable batteries. Any

other uses may result in risk of fire, electric shock or

electrocution.

♦ Do not expose charger to rain or snow.

♦ Pull by plug rather than cord when disconnecting

charger. This will reduce risk of damage to electric plug

and cord.

♦ Make sure that cord is located so that it will not be

stepped on, tripped over, or otherwise subjected to

damage or stress.

♦ Do not use an extension cord unless it is absolutely

necessary. Use of improper extension cord could result in

risk of fire, electric shock, or electrocution.

♦ Do not place any object on top of charger or place

the charger on a soft surface that might block the

ventilation slots and result in excessive internal

heat. Place the charger in a position away from any heat

source. The charger is ventilated through slots in the top

and the bottom of the housing.

♦ Do not operate charger with damaged cord or plug —

have them replaced immediately.

♦ Do not operate charger if it has received a sharp blow,

been dropped, or otherwise damaged in any way. Take

it to an authorised service centre.

♦ Do not disassemble charger; take it to an authorised

service centre when service or repair is required.

Incorrect reassembly may result in a risk of electric shock,

electrocution or fire.

♦ In case of damaged power supply cord the supply cord

must be replaced immediately by the manufacturer, its

service agent or similar qualified person to prevent any

hazard.

♦ Disconnect the charger from the outlet before

attempting any cleaning. This will reduce the risk of

electric shock. Removing the battery will not reduce this

risk.

♦ NEVER attempt to connect 2 chargers together.

♦ The charger is designed to operate on standard

household electrical power. Do not attempt to use

it on any other voltage. This does not apply to the

vehicular charger.

CHARGING

CHARGING THE SCREWDRIVER (FIG. 2)

Before the operation, read all safety warnings and instructions.

1. Connect the USB cable (i) to screwdriver connector (d)

and charger adaptor (j).

2. Plug the charger to electrical outlet.

3. During charging the charger indicator (e) is light on

and it will be light off when the battery is fully charged

4. Unplug the USB cable.

Before the first use, make sure to fully charge the battery

about 90min.

The charger is recommended to work at room temperature.

While charging, the battery and charger may become warm,

it is the normal situation and will continue until the battery

is fully charged and charger adaptor disconnected from the

electrical supply.

For long time storage, it is recommended to fully charge the

battery and store it in a cool and dry condition.

Warning! When disconnecting the screwdriver

from the charger, be sure to unplug the charger

from the outlet first then disconnect the charger

cord from the screwdriver.

Charging Process

Charging Status LED Indicator

Charging Red Light ON

Fully Charged Light OFF

Defect Battery

Light OFF

LI-ION BATTERY ONLY

Li-Ion batteries are designed with an “Electronic Protection

System” that will protect the battery against overloading,

overheating or deep discharge.

The tool will automatically turn off if the “Electronic

Protection System” engages. If this occurs, place the Li-Ion

battery on the charger until it is fully charged.

Important Safety Instructions for All Batteries

The battery is not fully charged. Before using the battery

and charger, read the safety instructions below. Then follow

charging procedures outlined.

READ ALL INSTRUCTIONS

♦ Do not charge or use battery in explosive

atmospheres, such as in the presence of flammable

liquids, gases or dust. Inserting or removing the battery

from the charger may ignite the dust or fumes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SCS4 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info