Bedienungsanleitung Stanley SFMCF900 (Seite 7 von 80) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

720809

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ENGLISH

(Original instructions)

Read the instruction manual before use.

Do not attempt to charge damaged batteries.

Electrical safety

Your charger is double insulated; therefore no

earth wire is required. Always check that the

mains voltage corresponds to the voltage on

the rating plate. Never attempt to replace the

charger unit with a regular mains plug.

● If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Stanley FatMax Service

Centre in order to avoid a hazard.

Mains plug replacement (U.K. & Ireland only)

If a new mains plug needs to be tted:

 Safely dispose of the old plug.

 Connect the brown lead to the live terminal in the

new plug.

 Connect the blue lead to the neutral terminal.

Warning! No connection is to be made to the earth

terminal. Follow the tting instructions supplied with

good quality plugs. Recommended fuse: 5 A.

Features

This appliance includes some or all of the following features.

1. Variable speed trigger switch

2. Forward/reverse button

3. 12.7 mm hog ring anvil

4. Battery (not supplied with unit)

5. Battery release button

6. LED work light

Assembly

Warning! Before assembly, remove the battery from

the tool.

Charging the battery (Fig. A)

The battery needs to be charged before rst use and

whenever it fails to produce sufcient power on jobs that were

easily done before. The battery may become warm while

charging; this is normal and does not indicate a problem.

Warning! Do not charge the battery at ambient

temperatures below 10 °C or above 40 °C.

Recommended charging temperature: approx. 24 °C.

Note: The charger will not charge a battery if the cell

temperature is below approximately 10 °C or above 40 °C.

The battery should be left in the charger and the

charger will begin to charge automatically when the cell

temperature warms up or cools down.

Note: To ensure maximum performance and life of lithium-ion

battery packs, charge the battery pack fully before rst use.

● Plug the charger (7) into an appropriate outlet before

inserting battery pack (4).

● The green charging light (7a) will blink continuously

indicating that the charging process has started.

● The completion of charge will be indicated by the green

charging light (7a) remaining ON continuously. The battery

pack (4) is fully charged and may be removed and used at

this time or left in the charger (7).

● Charge discharged batteries within 1 week. Battery life will

be greatly diminished if stored in a discharged state.

Charger LED Modes

Charging:

Green LED Intermittent

Fully Charged:

Green LED Solid

Hot/Cold Pack Delay:

Green LED Intermittent

Red LED Solid

Note: The compatible charger(s) will not charge a faulty

battery pack. The charger will indicate a faulty battery pack by

refusing to light.

Note: This could also mean a problem with a charger. If the

charger indicates a problem, take the charger and battery

pack to be tested at an authorized service centre.

Leaving the battery in the charger

The charger and battery pack can be left connected with the

LED glowing indenitely. The charger will keep the battery

pack fresh and fully charged.

Hot/Cold Pack Delay

When the charger detects a battery that is too hot or too

cold, it automatically starts a Hot/Cold Pack Delay, the green

LED (7a) will ash intermittently, while the red LED (7b) will

remain on continuously, suspending charging until the battery

has reached an appropriate temperature. The charger then

automatically switches to the pack charging mode. This

feature ensures maximum battery life.

Battery state of charge indicator (Fig. B)

The battery includes a state of charge indicator to quickly

determine the extent of battery life as shown in gure B. By

pressing the state of charge button (4a) you can easily view

the charge remaining in the battery as illustrated in gure B.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SFMCF900 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info