Bedienungsanleitung Stanley SFMCST933 (Seite 13 von 146) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

720561

Zoom out

Zoom in

Vorherige Seite

1/146

Nächste Seite

ENGLISH

2. Insert battery pack into the charger as described in the

charger section of thismanual.

Fuel Gauge Battery Packs (Fig.F)

Some STANLEYFATMAX battery packs include a fuel gauge

which consists of three green LED lights that indicate the level of

charge remaining in the batterypack.

To actuate the fuel gauge, press and hold the fuel gauge

button

25

. A combination of the three green LED lights will

illuminate designating the level of charge left. When the level of

charge in the battery is below the usable limit, the fuel gauge

will not illuminate and the battery will need to berecharged.

NOTE: The fuel gauge is only an indication of the charge left on

the battery pack. It does not indicate tool functionality and is

subject to variation based on product components, temperature

and end-userapplication.

Attaching Guard (Fig.B, C)



WARNING: Never remove the guard. Damage

or personal injury couldresult.



WARNING: NEVER OPERATE APPLIANCE

WITHOUT GUARD FIRMLY IN PLACE. The guard must

always be properly attached on the appliance to protect

theuser.

1. Remove the guard screws

16

2. Slide the guard

11

fully onto the trimmer head

8

Make sure the tabs on the guard engage the ribs on the

trimmerhead.

3. Continue to slide the guard on until it “snaps”into place. The

locking tab should snap into the housingslot.

4. Using a crosshead screwdriver, insert the guard screw and

tightensecurely.

5. Once the guard is installed, remove the covering from the

line cut-off blade, located on the edge of theguard.

Attaching the Auxiliary Handle (Fig.D)

For some models the auxiliary handle may need to be attached.

If the model needs the auxiliary handle attached, please refer to

theseinstructions.

1. To attach the auxiliary handle

5

, press in on the auxiliary

handle adjustment buttons

15

on both sides of the upper

housing as shown in Figure D.

2. Position the auxiliary handle as shown in Figure D . Partially

push the auxiliary handle on so it will hold the buttons in

when you release them with your hand.

3. Push the auxiliary handle completely onto the housing and

position it slightly until it “snaps” intoplace.

NOTE: To adjust the auxiliary handle up or down, press in on the

buttons and raise or lower the handle.

NOTE: The handle should be adjusted so that your front arm is

straight when the trimmer is in the workingposition.

Height Adjustment (Fig.E)



CAUTION: Adjust the length of the trimmer to

obtain proper workingpositions.

1. The overall height of the trimmer can be adjusted by

loosening the height-adjust collar

6

by rotating it in the

direction of the arrow shown in Figure E.

2. Move the upper housing straight up or down. When the

desired height is achieved, tighten the collar by rotating it

opposite of the direction shown in FigureE.

Releasing the Cutting Line (Fig.A)

In transit, the cutting line is taped to the spool housing

10

• Remove the tape holding the cutting line to the

spoolhousing.

OPERATION

Instructions for Use



WARNING: Always observe the safety

instructions and applicableregulations.



WARNING: To reduce the risk of serious

personal injury, turn tool off and disconnect battery

pack before making any adjustments or removing/

installing attachments or accessories. An accidental

start-up can causeinjury.

Proper Hand Position (Fig.A, I)



WARNING: To reduce the risk of serious

personal injury, ALWAYS use proper hand position

asshown.



WARNING: To reduce the risk of serious

personal injury, ALWAYS hold securely in anticipation of a

suddenreaction.

Hold the handle

4

with one hand. as shown in figure I

Switching Trimmer On and Off (Fig.A)



WARNING: Never attempt to lock the trigger

in the onposition.

To turn the appliance on, squeeze the lock-off button

2

and

then the On/Off trigger

1

. Once the unit is running, you may

release the lock off button. To turn the appliance off, release the

On/Offtrigger.

Speed Control Switch (Fig.A)

This string trimmer gives you the choice to operate at a

more efficient speed to extend the runtime for larger jobs, or

accelerate the trimmer speed for high-performancecutting.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SFMCST933 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info