Bedienungsanleitung Stanley SLM-139-460-SP (Seite 11 von 93) (Deutsch, Englisch, Dänisch, Italienisch, Portugiesisch, Schwedisch, Norwegisch, Finnisch)

720573

Zoom out

Zoom in

Vorherige Seite

1/93

Nächste Seite

release lever(21) towards the upper bar.

3. Fix the Bowden cables to the bar using the two cable

clamps(6).

4. Slowly pull the starter cord (23) on the starter handle

towards the bar and hook the starter cord into the starter

cord guide (22/Fig.6).

5. Lift the rear impact protection(7). Hook the grass

collection box (20) into the mounting provided for this on

the rear of the equipment. Release the impact protection

(Fig.8).

Caution: The mulch kit (27) and side ejection channel(28)

must be removed before using the grass collection box.

6. Dismantling the Grass Collection

Box: Lift the impact protection and remove the grass

collection box.

7. Caution: Before using the mulch kit (27), the side

ejection channel (28) must be removed.

- Remove the grass collection box if it is installed. Lift

the impact protection. Insert the mulch kit.

- Removing the Mulch Kit: Lift the impact protection.

Remove the mulch kit .

8. Caution: Before using side grass ejection (28), the

mulch kit (27) must be installed and the grass collection

box removed.

Install the mulch kit. Lift the side impact protection (16).

Hook in the side ejection channel (28) and release the

side impact protection.

5.2 Installing the operation panel (Fig.7)

Insert the operation panel into the upper handle. You

will hear it lock in.

Then tight it with the machine using 4 screws.

5.3 Filling with Engine Oil and

Checking the Oil Level

Place the equipment on a level base.

1. Unscrew the oil ﬁller cap and dipstick (8) and pour oil

into the tank.

2. To check the oil level, wipe the dipstick on a clean

cloth and replace it in the tank until it stops.

3. After pulling it out, read off the oil level on the

dipstick. The oil level should be in the marked area

between the minimum and maximum marks.

4. Wipe off any spilt oil and close the oil ﬁller cap .

5.4 Filling with Petrol

Warning! Petrol is ﬂammable and hazardous to

health:

- Keep petrol in containers intended for this purpose;

- Only refuel outdoors and never with the engine running

or when the machine is hot;

- Open the ﬁller cap carefully to allow excess pressure to

escape;

- Do not smoke whilst refuelling;

- Avoid skin contact and inhalation of the fumes;

- Remove spilt petrol;

- Keep petrol away from sparks,open ﬂames and other

ignition sources;

- Do not use petrol/oil mixtures;

- Use normal or super unleaded petrol;

- Only use clean, fresh petrol;

- Do not store petrol for longer than one month, as its

quality deteriorates.

1. Unscrew the ﬁller cap (9) and pour in the petrol to the

lower edge of the ﬁller. Do not ﬁll the tank entirely, to

allow the petrol room to expand.

2. Wipe away petrol residues around the ﬁller cap and

close the ﬁller cap.

6. Operation

General Working Instructions

• As far as possible, mow the lawn when it is dry in

order to protect the turf.

• Set the cutting height such that the equipment is not

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SLM-139-460-SP Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info