715258
18
Zoom out
Zoom in
Vorherige Seite
1/70
Nächste Seite
18
Getting started
The appliance is suitable for heating water only, everything else blocks the pump.
Safely install the device into a pot. The pot must be as high that the device hangs
into the water up till the marking “max” and a distance of at least 1 cm to the
ground is kept in order not to block the water circulation.
Please fill the pot with lukewarm water before use. Pay attention that the water,
together with the food, reaches the marking “max”.
Plug in the device.
If the water level is “min”, EE1 appears on the display and the device beeps three
times.
Setting the temperature and time
Switch on the device. The symbol ON/OFF, the power control light and the tem-
perature indication light up in blue. The device is in stand-by mode.
The operation of the touch screen works better with grease-free fingers.
Pres the ON/OFF button once, the temperature indication lights in °C. Note: if the
ON/OFF button is pressed for more than 3 seconds, you can choose between °C
and °F.
Use the +/- buttons to set the desired temperature in steps of 0,C up to 90°C.
Press the setting button once. The timer indication is blinking. Use the +/- buttons
to set the desired hours in steps of 1 hour up to 99 hours. By pressing the setting
button again, the minutes can be set in steps of 1 minute up to 59 minutes.
The program will be started by pressing the ON/OFF button, all LED’s of the display
are shining in blue.
After reaching the selected temperature, the device beeps twice, the blue LED
flashes and the timer starts to count down.
After the time has elapsed, the device beeps 3 times and the display shows “END”.
The power control light shines in red.
Plug off the device.
If you want to change the temperature or time during the cooking process, press
the ON/OFF button for 3 seconds. Then, temperature and time can be changed as
described above. Then, restart the device.
Water quantity
Do not put too much water in the device - leave sufficient room for the food. If neces-
sary, top up water until Max. The unit can be switched on only when the water level
reaches the max marking. The food must always be covered with water. The tempe-
rature sensor needs a couple of minutes until he adjusted to the set temperature if
pre-heated water is filled in. If there is no water in the pot, the device will not turn
on and beeps EE1. Turn off the appliance, add water and start again.
The water level sensor switches off the appliance when the water level drops
rapidly
If you plug the device out, or if you have a power outage, the unit remembers
the last set values.
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Steba SV 80 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info