Bedienungsanleitung Stiga 740 WX - P 901 CH (Seite 164 von 588) (Alle Sprachen)

608664

164

Zoom out

Zoom in

Vorherige Seite

1/588

Nächste Seite

• Cut grass frequently.

• Run the machine at full revs.

• Grass should not be wet.

• Only use sharp cutting means.

• Keep the bottom side of the cutting means

clean.

9 MAINTENANCE

9.1 ASSISTANCE PROGRAMME

To keep the machine in good working order in

terms of reliability, safety and environmental

protection, always adhere to the GGP servicing

programme.

The points of intervention for this programme

are illustrated in the attached GGP maintenance

manual.

The Basic Service must always be carried out by

an authorized service workshop.

The First Service and Intermediate Service should

be carried out by an authorized service workshop,

but can also be carried out by the user.

The procedures are indicated in the handbook and

are described in the chapter “7 START-UP AND

OPERATION” as well as here below.

The checks carried out by an authorized service

workshop guarantee professional workmanship

and the use of genuine spare parts.

The handbook is stamped every time a Basic Ser-

vice is performed and each time an Intermediate

Service is carried out by an authorized service

workshop. A handbook with these stamps increa-

ses the second-hand value of the machine.

9.2 PREPARATION

All service and all maintenance checks

must be carried out on a stationary ma-



Always apply the parking brake to stop

the machine from moving.

Stop the engine.

Prevent inadvertent start-up of the en-

gine by disconnecting the spark plug

cables and removing the ignition key.

9.3 MAINTENANCE TABLE

See chapter "13 MAINTENANCE SUM-

MARY TABLE". The table is designed to



and safe working order. It indicates the

main operations to be performed and

the frequency of the same. Perform the

relative operation described based on



Change the oil more frequently if the

      -

tions or when the ambient temperature

is high.

9.4 TYRE PRESSURE

Adjust the tyre pressure to meet the values provi-

ded in “0 TECHNICAL DATA TABLE”.

9.5 ENGINE OIL TOP-UP/CHANGE

For this maintenance operation, see

also the manual for the engine supplied

with the machine.

9.5.1 Inspection / top-up (21; 22)

 

To check the level, make sure the ma-

chine is on even ground.

Wipe around the dipstick. Unscrew it and

pull it out. Wipe the dipstick clean.

Push the dipstick down completely wi-

thout screwing it into place.

Now unscrew and pull the dipstick up



Top up if the level is lower than the

“FULL” mark (21; 22).

       

“FULL” mark. This results in the engine



“FULL” mark, the oil must be drained

until the correct level is achieved.

Change the oil more frequently if the engine has

to work in dicult conditions or when the ambient

temperature is high.

9.5.2 

For the frequency of this intervention

see chapter 13.

ENGLISH

(Translation of the Original Instructions)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiga 740 WX - P 901 CH Seite 164

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info