Bedienungsanleitung Stiga 740 WX - P 901 CH (Seite 163 von 588) (Alle Sprachen)

608664

163

Zoom out

Zoom in

Vorherige Seite

1/588

Nächste Seite

Warm start.

1. Engage the transmission (14:A1)

2. Activate the parking brake (10:B)

3. Turn the throttle to full on (11:A)

4. Turn the key in the ignition and start the en-

gine.

To proceed see the instructions provi-

ded in heading 7.7.1.

Models 4WD:

Cold start

1. Engage the transmission (15:A1; 15:B1)

2. Activate the parking brake (10:B)

3. Turn the throttle to full on (12:A)

4. Pull the choke out completely (12:B1).

5. Turn the key in the ignition and start the en-

gine.

Before starting work with the machine,

wait a few minutes for the oil to warm

up.

Warm start.

1. Engage the transmission (15:A1-B1)

2. Activate the parking brake (10:B)

3. Turn the throttle to full on (12:A)

4. The choke must be pressed in (12:B2).

5. Turn the key in the ignition and start the en-

gine.

To proceed see the instructions provi-

ded in heading 7.7.1.

7.7.1 Operation

To operate with the machine proceed as described

below:

• Press the pedal (10:B) right down then release

it.

• Activate the pedal (10:F) to move the machine.

• Go to the work area.

• If front accessories have been installed, activate

the PTO (11:D, 12:D).

• Commence work.

7.8 STOPPING

To stop the machine, proceed as follows:

• Disengage the PTO (11:D; 12:D).

• Engage the parking brake (10:B)

• Allow the engine to idle 1-2 mins.

• Turn o the engine by turning the ignition key.

• Close the fuel cock. This is particularly

important if the machine is to be transported on

a trailer for example.

If you have to leave the machine unat-

tended, disconnect the spark plugs and

remove the key from the ignition.

The engine may be very warm immedia-



     



7.9 CLEANING

 -

ne, silencer, battery and fuel tank free

from grass, leaves and oil

      

check the machine for oil and/or fuel

leaks.

     

This can damage shaft seals, electrical

components or hydraulic valves.

Always clean the machine after use. To clean

the machine adhere to the instructions provided

below:

• Do not spray water directly onto the engine.

• Clean the engine with a brush and/or

compressed air.

• Clean the motor cooling air intake.

• After cleaning using water, start the machine

and any cutting means assembly to remove

any water which may otherwise end up in the

bearings and cause damage.

8 USING THE ATTACHMENT

Make sure the grass to be cut is com-

 

stones etc.

8.1 CUTTING HEIGHT

For best results, cut o the top third of the grass.

See g. 23.

If the grass is long and needs cutting back signi-

cantly, cut twice using two dierent cutting heights.

Do not use the lowest cutting heights if the lawn

surface is uneven.

This would entail a risk of the cutting means being

damaged against the surface and the lawn’s top

layer of soil being removed.

8.2 MOWING TIPS

To get the best mowing results, follow the tips

given below.

ENGLISH

(Translation of the Original Instructions)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiga 740 WX - P 901 CH Seite 163

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info