Bedienungsanleitung Stiga PARK COMFORT (Seite 11 von 16) (Englisch)

575797

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

ENGLISH

Do not use the machine if the safety sys-

tem is not working! Take the machine

to a service workshop for inspection!

STARTING ENGINE

1. Open the fuel cock (fig. 12).

2. Make sure that the spark plug cable is properly

in place.

3. Check to make sure that the power take-off is

disengaged.

4. Do not keep your foot on the drive pedal.

5a. Comfort-President:

Starting cold engine – put the throttle control in the

choke position. Starting warm engine – put the

throttle control at full throttle (approx. 1 cm behind

the choke position).

5b. Royal-Pro16-Pro20:

Put the throttle control at full throttle. Starting cold

engine – pull the choke control out fully. Starting

warm engine – do not touch the choke control.

6. Depress the brake pedal fully.

7. Turn the ignition key and start the engine.

8a. Comfort-President:

Once the engine has started, move the throttle con-

trol gradually to full throttle if the choke has been

used.

8b. Royal-Pro16-Pro20:

Once the engine has started, push the choke control

in gradually if it has been used.

9. When starting from cold, do not make the ma-

chine work under load immediately, but let the en-

gine run for a few minutes first. This will allow the

oil to warm up.

When in use, always operate the engine at full

throttle.

STOPPING

Disengage the power take-off. Apply the parking

brake.

Allow the engine to idle 1 - 2 mins. Stop the engine

by turning off the starter key.

Shut off the petrol cock. This is particularly impor-

tant if the machine is to be transported on a trailer

for example.

If the machine is left unattended, re-

move the spark plug cable from the

spark plug. Also remove the starter key.

The engine may be very warm immedi-

ately after it is shut off. Do not touch the

silencer, cylinder or cooling fins. This

can cause burn injuries.

CATALYTIC CONVERTER

(Pro20 Cat)

The catalytic converter gets very hot during opera-

tion. The heat remains for a long time after the en-

gine has been stopped. Be aware of the fire risk.

Do not park in close proximity to in-

flammable objects. Do not cover the

machine until the catalytic converter

has cooled down.

STEERING AID (Pro20)

Built-in function in order to facilitate steering. The

operator only has to turn the steering wheel gently.

A hydraulic torque amplifier creates the remaining

force.

As opposed to normal servo steering (e.g. in a car),

the steering aid has a limited capacity. This means

that it has some characteristics that might be con-

sidered negative:

- at a low engine rpm or in situations where extra

steering force is needed, steering can be consid-

ered to be “jumpy”.

- the machine should always be moving when the

steering is used. Avoid turning the steering

wheel when the machine is standing completely

still and the accessory is in the lowered working

position.

The steering is adapted in order to produce better

results at a normal working speed. This produces

major benefits.

Even when the engine is not running, the steering

works. However, it is harder to turn in this case, if

the machine is to be manoeuvred manually.

DRIVING TIPS

Make sure that there is the correct quantity of oil in

the engine when driving on slopes (oil level on

“FULL”).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiga PARK COMFORT Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Stiga PARK COMFORT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info