Bedienungsanleitung Stihl HT 133 (Seite 9 von 96) (Englisch, Spanisch)

667254

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

HT 102, HT 103, HT 132, HT 133

English

Place the pole pruner on firm ground or

other solid surface in an open area or, in

the alternative, as shown in the above

picture. Maintain good balance and

secure footing.

WARNING

To reduce the risk of injury from loss of

control, do not attempt to "drop start"

your power tool. Drop starting means

pushing the machine away from the

operator, or allowing it to drop toward

the ground, while pulling on the starter

grip. This method is very dangerous

because you may lose control of the

machine.

WARNING

To reduce the risk of injury from loss of

control be absolutely sure that the guide

bar and chain are clear of you and all

other obstructions and objects, including

the ground, because when the engine

starts at starting-throttle, engine speed

will be fast enough for the clutch to

engage the sprocket and turn the chain.

Once the engine has started,

immediately blip the throttle trigger,

which should release the starting throttle

and allow the engine to slow down to

idle.

With the engine running only at idle,

attach the power tool to the spring hook

of your harness (see appropriate

chapter of this manual).

WARNING

When you pull the starter grip, do not

wrap the starter rope around your hand.

Do not let the grip snap back, but guide

the starter rope to permit the rope to

rewind properly. Failure to follow this

procedure may result in injury to your

hand or fingers and may damage the

starter mechanism.

Important Adjustments

WARNING

To reduce the risk of personal injury

from loss of control or contact with the

running cutting tool, do not use your unit

with incorrect idle adjustment. At correct

idle speed, the saw chain should not

move. For directions on how to adjust

idle speed, see the appropriate section

of your instruction manual.

If you cannot set the correct idle speed,

have your STIHL dealer check your

power tool and make proper

adjustments and repairs.

Proper chain tension is very important at

all times. Check it at regular intervals

(during work breaks and only when the

pole pruner is shut off). If the chain

becomes loose while cutting, switch off

the engine and then tighten. Never try to

tighten the chain while the engine is

running.

During Operation

Holding and Controlling the Power Tool

Always hold the unit firmly with both

hands on the handles while you are

working. Wrap your fingers and thumbs

around the handles.

Place your left hand on the shaft and

your right hand on rear grip and throttle

trigger. Left-handers must follow these

instructions, too. Keep your hands in this

position to help maintain control of your

pole pruner while working at all times.

WARNING

Never attempt to operate your power

tool with one hand. Loss of control of the

power tool resulting in serious or fatal

injury may result.

275BA006 KN

390BA026 KN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stihl HT 133 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Stihl HT 133

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info