Bedienungsanleitung Stovax View 7 Inset High Output Boiler Inset (Seite 23 von 44) (Englisch)

813428

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Installation Instructions

1. Installing the Appliance

WARNING - ALWAYS REMOVE THE GLASS PLINTH AND

GLASS TOP (IF FITTED) BEFORE UNDERTAKING ANY WORK

ON THE APPLIANCE.

Each installation is unique to the property so it is not possible

to give details to suit every setting. The installation must comply

with Building Regulations† and be made using "best practice"

construction methods‡.

Many fireplace openings have a supporting lintel. Do not remove

without supporting the remaining structure of the building. Do not

support the structure or the flue system with the appliance.

The flue system must be fully installed and supported according to

the manufacturers instructions BEFORE the appliance is installed.

1.1 Take care when installing the appliance. Careless handling

and use of tools can damage the finish and/or area.

This appliance is designed to be controlled by a

thermostat which regulates the rate fuel is burnt

and the amount of heat produced to hot water.

Note: It is recommended that the thermostat is fitted

before the appliance is installed. For installation

details refer to the instructions (PM747) supplied

with the thermostat kit.

1.2 Remove the door and all internal components before

proceeding (see Pre-Installaion, Sections 2 - 6).

Manoeuvring the appliance into the builders opening

will require 2 people.

1.3 Slide the appliance into the opening taking care not to

damage the hearth.

1.4 Check that the fit is suitable and the appliance is in the

correct position.

1.5 If the appliance is to be fixed to the hearth this must be

done before connecting the flue.

Hearth Fixing

It is recommended that this appliance is fixed to the hearth.

This must be done before connecting the flue.

1.6 There are 2 x keyhole slots in the base of the appliance

which can be used to attach it to the hearth, see Diagram 1.

This may damage some hearths, such as marble, granite

and limestone, which will be visible if the appliance is ever

removed. See below for an alternative fixing option.

1.7 Remove the base plinth.

1.8 Position the appliance where required on the hearth and

mark the location of the keyholes.

1.9 Drill the required size holes into the hearth.

1.10 Use suitable fasteners to fix the appliance in place.

Alternative Option:

If it is not desirable to create holes in a decorative hearth

the appliance can be fixed to the constructional hearth from

within the firebox.

1.11 Mark 2 x drill holes to the dimensions shown in Diagram 2.

100mm

200mm

2 x 8mm ø

1.12 Drill 2 x countersunk 8mm holes as marked. Please note:

the holes must be drilled all the way through the base to the

hearth and the countersunk recess must be deep enough to

ensure the screws will sit flush with the base of the firebox.

1.13 Carefully remove the appliance from the opening.

1.14 Using a masonry bit, drill corresponding holes in the hearth

and fit 2 x 6mm wall plugs.

1.15 Slide the appliance back into the opening taking care not to

damage the hearth.

1.16 Secure the appliance to the hearth using 2 x 6mm x 100mm

(minimum) countersunk screws. Do this before connecting

the flue.

† England and Wales – Document J / Scotland -

Part F/Document J (Republic of Ireland only)

‡ the latest edition of BS 8303, BS EN 15287,

BS 7566

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stovax View 7 Inset High Output Boiler Inset Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info