750859
25
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
English
NOTE: If, after a software update, the receiver should behave in an unexpected
way, please perform a factory reset as well. See chapter 7.1.4..
WARNING: After an update the receiver restarts automatically. During the upgrade
process NEVER disconnect the receiver from the mains or switch o the
power! Doing so might damage your receiver and will void warranty!
WARNING: Old channel list and favourites will be overwritten.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline or send email to our Support via www.strong.tv. Do NOT try to
open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem Possible cause What to do
LED indicator and
LED display are not
switching on.
The mains lead is unplugged.
Power switch at rear panel is
set to OFF.
Check the mains plug. Switch main
power to ON.
No signal found The antenna is disconnected
The antenna is damaged/
misaligned
Out of digital signal area
Active antenna requires
to switch ON the antenna
power/external power
Check the lead of the antenna
Check the antenna
Check with your dealer
Switch the antenna power of the
receiver ON/connect external power
No picture or sound on
TV or amplier
HDMI or SCART is not selected
on your TV or amplier or the
unit is set to higher resolution
as the TV supports.
TV/amplier is not switched
on
Switch to correct TV/amplier input
Select lower resolution on receiver
Switch TV/amplier on.
Check if S/PDIF connection is used.
Scrambled channel
message
Channel is scrambled Select an alternative channel
No response to the
remote control
The receiver is o
The remote control is not
aimed correctly
The front panel is obstructed
The batteries of the remote
control are exhausted
Plug in and turn on the plug
Aim the remote control at the front
panel
Avoid obstructions
Replace the batteries of the remote
control
21
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Strong SRT8213 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Strong SRT8213

Strong SRT8213 Bedienungsanleitung - Deutsch - 32 seiten

Strong SRT8213 Bedienungsanleitung - Französisch - 28 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info