Bedienungsanleitung Suntec Klimatronic ENERGIC plus 9.0 (Seite 19 von 192) (Alle Sprachen)

664820

Zoom out

Zoom in

Vorherige Seite

1/192

Nächste Seite

If you press the [POWER] switch before the time has expired, the time programming is deleted, the

ENERGIC unit switches on and can be operated in the required operating mode.

Residual time: This function is used to automatically deactivate the ENERGIC unit when the time entered

has expired. Proceed as follows:

a) Press the [TIMER] switch during operation and enter the required number of hours after which the

ENERGIC unit is to switch off.

b) After the flashing of the number of hours on the LED has stopped, you can select the required function

(cooling, heating, dehumification) and the required temperature.

c) When the set number of hours has expired, the ENERGIC unit switches on automatically.

If you press the [POWER] switch before the time has expired, the Timer programming is deleted and the

ENERGIC unit switches off.

8. [SLEEP]

Using this key you can set the sleep function of the ENERGIC unit. The microprocessor integrated in the

ENERGIC unit will raise the pre-set temperature by 2°C per hour up to a maximum of 4°C after 2 hours

and maintain this temperature until the set time has expired.

If you use the sleep function, first set the time switch to the set hours as described in the functions

Residual time or Starting time. Then press the [TIMER] switch until the required hours appear on the

display. After the hour display, the display switches automatically to the previous set temperature display.

To change the temperature, press the switch [TEMP+] or [TEMP-]. With each press on the switch, the

temperature increases or decreases by 1°C.

COOLING

 We recommend starting ENERGIC early in the morning on warm days to get a cool room.

 This ENERGIC unit has a self-evaporation function for condensation water, so that it is normally not

necessary to empty the water tank in cooling mode. The drainage hose need not be connected.

Please make sure that the outlet is closed with the rubber cap during operation.

(This does not apply in the case of high air humidity. If the ENERGIC unit operates in cooling mode for a longer

period and especially at a time of year with high air humidity, the condensation tank may be full. The control lamp

will remind you to empty the water. Refer to error message E4. In such a case, empty the water tank via the

condensation water outlet. If continuous high air humidity is likely, it is recommended to drain the condensation

continuously via the drainage hose.)

COOLING IN INDOOR OPERATION

The ENERGIC unit stands in the room to be cooled.

Connect the air hose and the air outlet grid to the ENERGIC unit as displayed in the illustration; the air

hose connection piece and air outlet grid need to be exchanged.

The warm extract air must be emitted from the room via the air hose. This can be executed e.g. via a tilted

window, a door or wall aperture. Make sure that no warm outside air can enter the room. For effective

cooling, we recommend our selection of various accessories which reduce or prevent entry of warm air

into the room.

Set the function to „COOLING“. Set the target temperature using the temperature control. The settable

temperature range is between 17°C and 30°C target temperature. The ENERGIC unit must only be used

in an ambient temperature of maximum 35°C.

Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control lamp has

flashed for 3 minutes. Cooling effect may require a further 10 minutes. Further information is available under the item,

„Troubleshooting“.

COOLING IN OUTDOOR OPERATION

The ENERGIC unit is outside the room to be cooled.

Connect the air hose and the air outlet grid to the ENERGIC unit as displayed in the illustration; the air

hose connection piece and air outlet grid need to be exchanged.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Suntec Klimatronic ENERGIC plus 9.0 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info