Bedienungsanleitung Suntec Klimatronic ENERGIC plus 9.0 (Seite 21 von 192) (Alle Sprachen)

664820

Zoom out

Zoom in

Vorherige Seite

1/192

Nächste Seite

The cold extract air has to be led out of the room via the air hose. This can be executed e.g. via a tilted

window, a door or wall aperture. Make sure that no cold outside air can enter the room. For effective

heating, we recommend our selection of various accessories which reduce or prevent entry of cold air into

the room.

Set the function to „Heating“. The settable temperature range is between 15°C and 25°C target

temperature. You can set this using the temperature control.

Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control

lamp has flashed for three minutes. Cooling effect may require a further 10 minutes. Further information is

available under the part „Troubleshooting“.

HEATING IN OUTDOOR OPERATION

The ENERGIC unit is outside the room to be heated. Outdoor operation is ideal for the transition period in

which outside temperatures do no fall below 7°C. (If the outside temperature should however fall below 7°C

continuously, we recommend indoor operation). Connect the air hose and the air outlet grid to the ENERGIC

unit as displayed in the illustration, the air hose connection piece and air outlet grid need to be exchanged.

Set the function to „Heating“. The settable temperature range is between 15°C and 25°C target

temperature. You can set this using the temperature control.

The air with high oxygen content heated by the ENERGIC unit is fed into the room via the air hose. This

can be executed e.g. via a tilted window, a door or wall aperture. Make sure that no cold outside air can

enter the room. For effective heating, we recommend our selection of various accessories which reduce or

prevent entry of cold air into the room.

Using the “Comfort Control- S Kit“ you can also control the ENERGIC unit from inside using the remote

control.

Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control

lamp has flashed for 3 minutes. Cooling effect may require a further 10 minutes. Further information is

available under the part „Troubleshooting“.

DEHUMIDIFICATION

Humidity is extracted from the air, collected in the water tank and discharged via the condensation water

outlet. Only air the room if the humidity of the outside air is below than in the inside room. Set the function

to “Dehumidity”.

The rubber plug of the condensation water outlet is removed and a drainage hose attached. To collect the

condensation water easily in a tank, a drainage hose is included in the scope of delivery which you can

connect to the upper condensation water outlet. Allow water to flow out continuously in order to achieve

higher dehumification capacity. In the dehumidify mode, you must not feed the room air outside with the

extract air hose.

Caution: In the dehumidify mode, separate setting of the ventilator is not provided, since the

lowest ventilation level is already preset to ensure efficient dehumidification of ambient air.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Suntec Klimatronic ENERGIC plus 9.0 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info