Bedienungsanleitung Tascam CD-RW901MKII (Seite 20 von 44) (Englisch)

587263

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

20 TASCAM CD-RW901MKII

4 − Playback operations

Time display switching

When the TIME key on the front panel or the remote control

is pressed, the time display will switch through several modes

on the display.

•

Elapsed track time (no display light indication)

•

Remaining track time (REMAIN is lit in the display)

•

Elapsed disc time (TOTAL is lit in the display)

•

Remaining disc time (TOTAL and REMAIN are lit in the display)

When stopped, the total recording time is shown, regardless of

the status of the TOTAL and REMAIN indicators.

NOTE



In program mode, pressing the TIME key displays the

elapsed and the remaining time of the whole program.

When playing an MP3 disc, elapsed track time is

always displayed, and the TIME key cannot be used.

For details on time display during recording, please

refer to “Time display while recording” on page 27.

Even when power is turned off, the time display mode

setting is retained.

Random playback

In this mode, the unit will play back all the tracks on the disc in

completely random order, regardless of track number.

When stopped, set the mode to display Random or

Mode>Random. Press the PL AY key and random playback will

begin.

NOTE



Even when the power is turned off, the unit will

remain in Random mode.

Program playback

This function enables playback of selected tracks in any

desired order. Up to 99 tracks can be selected for program

playback.

1. When stopped, set the mode to display Program or

Mode>Program.

2. Use the number keys (0~9) on the remote control

unit to select each desired track for program play-

back, then press the ENTER key.

You can also rotate the MULTI JOG dial to select the

track number and push to enter.

The track number will be entered into the program.

Repeat the above step 2 until the desired program is completed.

As the program is being created, the program number and total

program playing time is revised on the display.

NOTE



If the CLEAR key is pressed, the programmed track

will be deleted from the last.

3. When program setting is completed, press the

PLAY key to begin playback of the tracks in the

programmed order.

NOTE



If the STOP key is pressed without ﬁrst pressing the

PLAY key, all the program data will be erased.

When stopped, if the playback mode is switched to

another, all the program data will be erased.

The programmed play order is not memorized when

power is turned off.

In this mode, if there are no tracks programed, the

CD-RW901MKII will not start playback.

If an attempt is made to enter more than 100 program

steps, the message PGM Full! appears on the display.

If the total program playing time exceeds 999 min 59

sec, --- : -- appears on the display.

Single-track playback

This function enables playback of just a single track.

1. When stopped, set the mode to display Single or

Mode>Single.

2. Use the SKIP keys or the number keys (0~9) on

the remote control to select the desired track. The

MULTI JOG dial can be used to select the track also.

3. Press the PLAY key to begin playback.

After the selected track finishes, playback stops.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tascam CD-RW901MKII Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info