617905
31
Zoom out
Zoom in
Vorherige Seite
1/72
Nächste Seite
TASCAM HS-8 31
3 Touch the knob that you want to adjust. Use the
DATA dial on the front panel to adjust its value.
TIP
Press the DATA dial as you turn it to make adjustments in larger
increments. This is useful for making rough adjustments quickly.
CALL
Press the CALL (CHASE) key to locate to the point where
playback was last started from standby and put the unit in
playback standby mode.
Flash start function
Use the flash start function to instantly start playback
of takes that you have designated in advance. The
beginnings of up to 20 takes can be stored in the units
memory beforehand so that playback can be started
immediately. Flash start can be executed using the unit’s
touch screen, a PS/2 keyboard connected to the front
panel or an external controller connected to one of the
units remote control connectors (REMOTE, RS-232C and
PARALLEL).
1 Select the folder that contains the file you want to
play back. (See “Loading folders on page 38.)
2 Press the HOME key on the front panel to open the
Home Screen.
3 When the Home Screen is open, press the HOME
key again to open the Flash Start screen.
4 Use the DATA dial to select the page of the Flash
Start screen that contains the takes you want to
enable or flash playback.
NOTE
The Flash Start screen contains ve pages with 20 takes shown on
each.
5 Touch the “FLASH LOAD” button or press the DATA
dial to load a take. While loading, the icon
blinks. When loading has completed, the icon
appears green.
6 All of the takes shown are loaded. The “FLASH
LOAD” button changes to say “FLASH LOADED” and
its background becomes orange. Takes that have
been properly loaded have an orange flash start
indicator in the upper left.
7 Touch the button on the touch screen for a take
that shows an orange flash start indicator to start
flash playback.
Flash start playback can also be executed using a
PS/2 keyboard or an external controller connected
to one of the units remote control connectors
(REMOTE, RS-232C and PARALLEL).
NOTE
Touching the button of a take that has not been ash loaded
will cause it to start playback normally.
Touch the “INFO” button to open an information screen. The
contents of this screen are the same as shown on the infor-
mation screen that opens when the Home Screen “INFO” button
is touched.
When using the ash start function, tracks cannot be soloed.
(Touching the the level meter will not solo the corresponding
channel. Moreover, if solo is enabled for any channels, it is
automatically turned o when the Flash Start screen is opened.
4 − Recording and Playback
31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Tascam HS-8 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info