Bedienungsanleitung TC Helicon VoiceLive Rack (Seite 46 von 89) (Englisch)

658357

Zoom out

Zoom in

Vorherige Seite

1/89

Nächste Seite

REVERB Tab Overview

This tab allows you to congure a global Reverb

style that does not change as you change presets.

This can be useful when you want to, for exam-

ple, change from one Harmony preset to another

for a different interval arrangement yet you prefer

the base Reverb effect to remain.

f GLOBAL REVERB ENABLE

This is the master on/off for global Reverb. When

set to OFF, this is the only parameter visible in the

tab. When turned ON, the full range of Reverb

control parameters becomes visible.

When global Reverb is active, tapping the front

panel Reverb button will turn this effect on or

off globally. As such, reverb will remain on or off

respectively as you load different presets. A pop-

up will appear in the display briey showing global

Reverb on or off status.

Holding the Reverb button to edit while global

Reverb is active will present the global REVERB

tab from the Setup menu and light the Setup

button.

f STYLE

Use the soft knob assigned to this parameter to

choose a pre-programmed reverb style you like.

f LEVEL

Sets the mix level for the Reverb effect.

f WIDTH

Sets the stereo imaging of the Reverb effect. 0% is

mono, 100% is fully stereo.

f DECAY

Sets the length of the reverb tail from 10mS

to 20 seconds. Note that, due to the complex

nature of Reverb algorithms, a decay time of 4

seconds may sound quiet different from one style

to the next, even when the rest of the settings

are identical.

f LO COLOR / HI COLOR

These are preset-frequency lters inserted into

the Reverb feedback path that tailor the low and

high frequency response and decay of the tails.

Values toward -50 will cut response in its respec-

tive band and a values toward 50 increase re-

sponse.

f HI FACTOR

This allows you to raise or lower the level of the

high band of the Reverb tail independently.

f EARLY REFLECTIONS / TAIL LEVEL

These parameters allow you to attain the right

balance between reections you would hear

from close surfaces (EARLY REFLECTIONS) with

those from surfaces further away (TAIL LEVEL).

The settings for the early reections in each style

are slightly different but non-editable.

f DUCKING

When DUCKING is set to ON, the Reverb

block’s output will be reduced while you are sing-

ing. At the end of a sung phrase, the effects return

to the level you set, increasing the clarity of your

vocals while still sounding very “wet”. The amount

of attenuation and attack time for ducking are set

with the DUCKING AMOUNT and DUCKING

TIME parameters further down in this menu.

f DIFFUSE

Also known as Diffusion, this is a very subtle pa-

rameter used to simulate and control the density

of the reections inherent in real acoustic spaces.

Low DIFFUSE values (-25 to 0) are intended to

The Setup Button

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

TC Helicon VoiceLive Rack Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von TC Helicon VoiceLive Rack

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info