Bedienungsanleitung Team CMM 5 (Seite 10 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

486906

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don’t change the page numbering. Keep the

language integrity.

10 TEAM CMM 5 - 101214

Assembly page 10/52

Fax +32 2 359 95 50

 The appliance is designed for the preparation of small quantities of food that have to be

consumed rather quickly. It is not designed for the preparation of large quantities at once.

 Never touch the blade when the appliance is in use. Furthermore, never try to stop the

movement of the blade in any way whatsoever.

 We recommend that when using your product you operate the motor unit in short on/off

pulses. This will give better chopping, mixing, etc. It will also ensure a long-lasting

performance of your motor. Please refer to the information at the end of this instruction

booklet for recipe information and operating guidelines.

 The chopper is designed to be used exclusively in its delivery state (bowl, lid and blades in

good state) because it gives all the needed securities. Do not try to substitute one of those

pieces by another one and if you have to replace one, contact your after sales service.

(*)

Competent qualified electrician: after-sales department of the producer or importer or any

person who is qualified, approved and competent to perform this kind of repairs in order to

avoid all danger. In case of need you should return the appliance to this electrician.

IMPORTANT INFORMATION

This appliance is not intended for long-lasting use. You should never exceed the maximum

operating time indicated in the table below (see page 12). Failure to follow this instruction

carefully may result in damage to the motor. Please make some operation breaks regularly.

The breaks should last at least 10 minutes.

BEFORE THE FIRST USE

 Remove all packaging, and check that no parts are damaged or missing.

 Read these instructions carefully!

 Wash the bowl, lid, chopper blade and axle unit in warm soapy water and dry thoroughly.

 Wipe the motor unit and lid of the chopper with a damp cloth.

 Rinse the leg under warm running water, wipe the blade with a damp cloth and dry

thoroughly.

 Remove the stainless steel whisk from the whisk body and wash in warm soapy water, wipe

the whisk body with a damp cloth and dry thoroughly.

SPEED SETTINGS

Depending on the accessory you are using, we recommend you to use the following speed

setting.

STICK ATTACHMENT: speed I or II

WHISK: speed I

CHOPPER: speed I or II

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team CMM 5 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info