Bedienungsanleitung Team SIS 7 (Seite 10 von 40) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487283

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don‟t change

the page numbering. Keep the language integrity.

10 TEAM SIS 7 - 070326

Assembly page 10/40

Fax +32 2 359 95 50

 Proceed the same way if the water tank stops working or is damaged. To avoid the risk of

electric shock, do not disassemble the iron or steam tank, take it to a qualified technician

for examination and repair. Incorrect re-assembly can cause a risk of electric shock when

the iron or steam tank is used.

 Fully unwind the mains cord and supply hose before starting to iron.

 The steam tank switch should always be turned to “0” before plugging or unplugging the

power cord from outlet.

 Unplug the appliance and allow the iron and the water tank cool down before cleaning

or storing them and for pressurized steam iron station (depending on the model) before

opening, filling or emptying the water tank.

 FOR PRESSURIZED STEAM IRONING STATION (DEPENDING ON THE MODEL), NEVER UNSCREW

THE CAP OF THE STEAM TANK WHILE THE APPLIANCE IS CONNECTED TO THE MAINS WALL

SOCKET AND ESPECIALLY WHEN STEAM IS BEING PRODUCED.

(*)

Competent qualified service: after sales department of the producer or importer or any

person who is qualified, approved and competent to perform this kind of repairs in order to

avoid all danger. In any case you should return the appliance to this service.

STEAM IRON: USE PRECAUTION AND TEMPERATURES

 Always check first if a label with ironing instructions is attached to the article to be ironed.

Follow these ironing instructions in all cases.

 If ironing instructions are missing but you know the kind of fabric, then see the table for

recommended ironing temperatures.

 As soon as you plug in the appliance, the iron is switched on, even if you haven't

activated the water tank's switch. The power light (3) switches on as soon as you plug in

the appliance. Put the switch (1) on “I” position. Set the temperature dial of the iron (6) to

the desired position. The pilot light of the iron (8) will come on, indicating that the iron is

heating. As soon as the desired temperature is reached, the pilot light will go out, you can

start ironing.

 During ironing this pilot light (8) will come on from time to time. When this happens, the

soleplate is being heated-up to the required temperature again. You can continue

ironing.

 The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,

wrinkle, relief etc), the textile can best be ironed at a lower temperature.

Kind of textile

Temperature dial

Steam ironing

Synthetic (e.g. acetate,

acrylic, viscose,

Polyamide, polyester, ….)

Silk

MIN







Wool







YES

Cotton

Linen







MAX

YES

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team SIS 7 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info