Bedienungsanleitung Team SIS 7 (Seite 11 von 40) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487283

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don‟t change

the page numbering. Keep the language integrity.

11 TEAM SIS 7 - 070326

Assembly page 11/40

Fax +32 2 359 95 50

First sort out the fabrics according to ironing temperature: wool with wool, cotton with

cotton, etc.

The iron heats up quicker than it cools down. Therefore, start ironing the articles requiring

the lowest temperature such as those make of synthetic fibres. Then progress to the higher

temperatures.

 If the article is made of a mixture of different fibre, you must always select the lowest

ironing temperature of the composition of those fibres.

(E.g. an article consisting of “60% polyester and 40% cotton” should be ironed at the

temperature indicated for polyester and without steam).

If you do not know what kind(s) of fabric(s) the article has been made of, find a spot,

which will be invisible when wearing or using the article to try out the ironing temperature.

(Always start at a low temperature and increase to one, which gives the required results).

 Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. It is

recommended to apply shot-of-steam and use a dry pressing cloth.

When steam-ironing woollen fabrics, shining of the fabric may occur. This can be

prevented by turning the article inside out and ironing the inside or by interposing a light

damp cloth.

 Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction

only (with the nap), applying only light pressure.

Always keep the iron moving.

 Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this

may cause stains.

FILLING WITH WATER (FOR STEAM-IRONING)

1. Put the base on a stable surface.

2. Press the release button (5) of the water tank and slide it forward. Turn the cap (13)

clockwise until the line on the cap ends up in front of the slots of the water tank and pull it

out. Fill the water tank with clear water up to its "Max" level. You can use tap water, but we

advise you to use demineralised water.

3. Close the cap (13) of the water tank. Put it in its place and turn it anticlockwise until the

lines on the cap are no longer in front of the slots of the water tank.

4. Put the water tank back in the base correctly. Slide it backward until it is locked.

5. Never use vinegar, detergents or other chemical products.

Caution: always make sure that the anti-scale cartridge situated underneath the water tank is

well into place. Never use the appliance without anti-scale cartridge.

FILLING THE WATER TANK DURING USE

As the water tank of this appliance is not under pressure, you can refill it during use. To dos o,

just proceed as described above in the "Filling with water" section).

STEAM-IRONING

 Fill the water tank with water and insert the mains plug into a wall socket.

 As indicated on the temperature dial (6) and the table, steam ironing is only possible at

higher ironing temperatures, so set the dial to  or .

 When you plug in the appliance, the power light (3) will come on. It stays on permanently,

indicating that the appliance is connected to the mains.

 Put the steam switch (1) in ON position ("1") and set the temperature dial of the iron (6) to

the desired position. When the iron has reached the desired temperature, its pilot light (8)

will go out. You can now use the steam function.

 Press the steam button (7) to release steam from the soleplate of the iron. The pump pilot

light (2) will switch on every time you press the steam button. Release the button and the

steam will stop. If you want a continuous jet of steam, hold the steam button down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team SIS 7 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info