Bedienungsanleitung Team VX-2412 (Seite 11 von 31) (Deutsch, Englisch, Holländisch, Spanisch)

749136

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

English TEAM VX-2412

EnglishVX-2412

General :

• The frequency range of the antenna has to cover the programmed fre-

quencies on the radio.

• The position of the antenna should be as elevated and unobstructed as

possible.

• Ensure that the cable and the connector of the antenna are intact and

that the plug is connected properly.

• Ensure that the cable is not bend too much.

• The length of the antenna rod and the range of operation are related. The

longer the rod, the further the distance.

• Upon antenna-mounting, the following has to be considered :

• The antenna should be placed in the middle of a vehicle part.

• The antenna base should have good contact to a metal, conductive sur-

face of the vehicle.

• To avoid interferences with radio and TV reception, place the antenna as

far away as possible from these sources of interferences.

Antennas are available with a magnetic mount or as xed units.

Antenna Connection

Connect the antenna connector of the cable with the PL-jack (9), located on

the rear of the radio. Ensure a proper connection of the cable to the antenna

base. Improper connections can cause damages to the radio and a reduction

of the operational range may be the result.

The antenna setup has to be adjusted to the radio. Otherwise, a part of the

transmission power is reected at the antenna and is not radiated. A reduced

range of operation could be the consequence.

Power Supply Connection

The voltage has to be 13.8 V or 24 V DC with negative grounding. Ensure that

the positive and (+, red) and negative (-, black) polarity is correct, before you

connect the radio.

The wiring has to be done by an authorized technician.

Connect the power cable directly with the battery. Do not use a cigarette

lighter adapter because this kind of connectivity might not provide enough

currant for a proper operation of the radio. Pay special attention to the correct

polarity, when connecting the cable onto the battery.

CAUTION

• Please ensure proper polarity.

• Please check the fuse before rst use of the radio. Missed or defect fuses

need to be replaced before operation of the radio.

Fuse

The power supply cable xed to the VX-2412 is equipped with one 15A/250V

fuse. Beware using the correct, according fuse. Damages to the radio can

occur when using the wrong fuse.

If the fuse blows, determine the cause, then solve the problem. After the

problem is resolved, replace the fuse. If newly installed fuses continue to blow,

disconnect the power cable and contact your authorized dealer or an autho-

rized service center.

External Speaker

External 8 Ohm speakers must have a 3.5 mm plug which has to be con-

nected to the speaker connection (9). Beware of the length of the cable when

determining the position.

Microphone Connection

Plug the microphone plug into the 6-pin socket (3), located on the front panel,

and tighten the union nut. Pay attention to proper placement. No transmission

is possible without the microphone.

Please note that for transmission, the microphone has to be connected.

OVERVIEW FUNCTIONS

• 38 CTCSS / 104 DCS Codes

• VOX - Sensitivity and Delay

• Multi Frequency Norm

• LCD with seven background colors and 6 brightness levels

• Squelch - automatic and manual

• Channel Scan

• RF Gain

• Priority Channels 9/19

• AM / FM Mode

• Channel Selectors Up and Down, at Radio and Microphone

• Connector for external Speaker

• Automatic 12/24V Switch

• Keylock

• Beep Tone, on/o󰀨

• Automatic Noise Limiter / Noise Blanker (ANL/NB)

• Talkback

• HI-CUT

• Roger Beep

• S-Meter for Tx and RX

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team VX-2412 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info