Bedienungsanleitung Tesco SM16 (Seite 4 von 8) (Englisch)

770539

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Assembling Your Cleaner for Cleaning Floors

Page 4

1 2 3 4 5 6

Attaching the Handle and the Floor Head

There is a peg in the handle stem. Line up the peg in the stem with the hole in the cleaner housing and push it in. The peg will 1.

click into place securing the handle. You may need to push quite hard to insert the handle fully - it is an intentional tight t.

Line up the oor head with the nozzle in the body and push rmly. Now pull the oor head back slightly to check that it is 2.

securely attached.

Attaching the Cleaning Pad: Whenever you clean oors the cleaning pad must be rmly attached to the oor head. We recommend

you wash and and dry the cleaning pad before rst use to ensure that there are no lint particles adgering to the surface.

Around the edge of the cleaning pad there is a “hook and loop” strip. Place the cleaning pad on the oor with the strip facing 3.

up and align the cleaner over the pad.

Place the oor head on the pad and press lightly with your foot to attach the pad securely.4.

Attaching the Carpet Glider: Use the carpet glider only when you are refreshing carpeted surfaces.

Place the carpet glider on the oor as shown and align the cleaner over it..5.

Place the oor head on the glider and press lightly with your foot to attach the carpet glider securely.6.

Filling the Water Tank

7. Remove the water tank. Press the release button on the top of the tank and hinge the tank out.

8. Lift out the stopper on the tank. Fill the tank with fresh cold water or demineralised water (see Page 2) to a level just below the

top of the tank.

9. Push the stopper in rmly and replace the tank.

Filling the Solution Tank

Special detergent solutions are available. These solutions act with the steam to improve cleaning, refresh carpets and enhance

special nishes on solid oors. Always consult the oor manufacturer or a specialist professional before using detergent solutions

and always adhere strictly to the instructions on the detergent packaging concerning dilution levels etc. Always try the solution

on a test (hidden) area to check colour fastness and suitability before use.

10. Rotate the tank cap to the left to release it and then lift it o.

11. Press the “DETERGENT” switch on the oor head to the OFF position and ll the tank with the correctly prepared solution to

just below the top of the tank. Replace the tank cap and tighten rmly. When lling the tank take care not to spill solution on

the oor. If you wish you can remove the tank (see Page 7) and ll it over a sink

Winding and releasing the mains cord

12. Wind the cord around the upper and lower cleats on the rear of the stem. The upper cleat is a quick

release type. Rotate the cleat to release the cord. When the cord is released return the cleat to the

vertical position. There is a slot in the top of the upper cleat. If you wish you can push the cable into

the slot to keep the power cord from getting in the way.

Your steam cleaner is now ready for use.

7 8 9

10 11

Open

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tesco SM16 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info