Bedienungsanleitung Thomson THS 845 (Seite 7 von 32) (Englisch)

658771

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

INTRODUCTION

English

• It is a necessity that you only use an approved extension and compatible wiring that is suitable for the

electrical power consumption of the installed equipment. Please ensure that the electrical power supply

corresponds with the voltage on the electrical identification plate at the back of the receiver.

If the receiver does not operate normally, even after strictly following the instructions in this user manual it

is recommended to consult your dealer or the appropriate service for your country.

1.2 Storage

Your receiver and its accessories are stored and delivered in a packaging designed to protect against

electric shocks and moisture. When unpacking it, make sure that all the parts are included and keep the

packaging away from children. When transporting the receiver from one place to another or if you are

returning it under warranty conditions, make sure to repack the receiver in its original packaging with its

accessories. Failing to comply with such packaging procedures could damage the product and void your

warranty.

1.3 Equipment Set-up

We recommend you to consult a professional installer to set up your equipment. Otherwise, please follow

the instructions below:

• Refer to the user manual of your TV and your antenna.

• Make sure that the HDMI cable and outdoor components are in a good condition and the HDMI

connections are well shielded and from good quality.

This user manual provides complete instructions for installing and using this receiver. The symbols serve as

follows.

WARNING: Indicates warning information.

NOTE: Indicates any other additional important or helpful information.

MENU Represents a button on the remote control or the receiver.

(Bold characters)

Move to Represents a menu item within a screen.

(Italic characters)

1.4 Accessories

• 1x user manual

• 1x remote control unit

• 2x 3 V Lithium CR2032 batteries

• 1x adapter 12 Volt DC, 2 Ampere

• 1x HD+ smart card

1.5 Usage of external USB devices

• It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0

specifications, recording and playback with your receiver might not work properly.

• If you are going to use external USB HDD (Hard Disk Drive) please consider that the power specifications

might exceed the supported output of your receiver (5V/500 mA). If so, please connect your USB HDD to

an according external power adapter.

• THOMSON cannot guarantee compatibility with all types of USB storage devices.

• It is advised not to store important information on USB storage devices used with the receiver. Always

make backups of data on your USB storage device before using it with this receiver. THOMSON will not

take responsibility for any loss of information or circumstances caused by loss of information.

• Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB device

via your receiver. Formatting requires entering the PIN code (default ‘0000’)

• THOMSON cannot guarantee the playback of all files although extensions are listed, as it depends on file

size, codec, bit rate and resolution.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thomson THS 845 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info