658771
22
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
P18
CONTROL PANEL
the identified source. In order to update from a USB disk, you need to download the updated software file
from our website to the root directory on the USB disk first.
The USB disk should be plugged in the USB port before executing the System Update option. Do not
remove the USB disk until the complete software update process is completed. In order to update over
the Internet, the receiver must be connected to the Internet over a LAN or WLAN connection. Remove any
USB device from the USB port before you execute the System Update option. If the System Update option
is executed but there is no USB disk connected and no Internet connection, the receiver will search for a
newer software version over the satellite. This procedure may take very long time depending on the size
of the new software file and therefore it is recommended to use the USB or Internet methods described
above for software updates. After the new software file was downloaded, the receiver will store the new
software and automatically restart. All user preferences and channel lists will remain unchanged.
ATTENTION: Be careful not to interrupt the software update process by removing the USB stick,
disconnecting the Internet or turning off the receiver, or otherwise interrupting the installation
process. If the installation is interrupted by accident, such as by a power failure, the receiver
may not boot up properly afterwards.
9.11 System Information
This menu displays information related to the software and hardware version of the receiver. This
information may be required if you request service or repair.
9.12 Audio/Video Settings
This is where you can set the basic audio and video parameters of your receiver related to connections on
the rear panel.
9.12.1 Digital Audio Out
Use this option to specify desired audio format on the digital audio outputs (SPDIF / HDMI). Please check
that your TV supports Dolby Digital and DTS over HDMI.
9.12.2 HDMI Video output
Use this option to specify the video output format on the HDMI connector.
Dolby DRC Use this option to set the Dynamic Range Control when using Dolby technology.
Line is more suitable for effects reproduction, while RF produced a higher voice level.
Audio track Use this option to select a preferred audio track language.
9.12.3 HDCP
Use this option to set HDCP protocol over the HDMI connection On or Off.
9.12.4 Analogue video output
Use this option to enable/disable the analogue video outputs.
9.12.5 Adaptive scan HDMI
Use this option to adjust the screen frequency over the HDMI connection to allow for optimal picture
quality during video playback.
9.13 Antenna Settings
Antenna setting options were described under the Installation Wizard chapter.
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Thomson THS 845 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info