Bedienungsanleitung Thomson THT700 (Seite 17 von 22) (Englisch)

658773

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

MAIN MENU

P13

English

Time Offset: Choose Auto to synchronise time and time zone automatically, or Manual to

specify the time zone manually.

Region: The country cannot be adjusted because there is only one time zone within

Austria.

Time Zone: This setting is only available when Time Offset is set to Manual.

When switching from wintertime to Summer Time, at the Manual time setup you will need to adjust the

correct setting here.

6.2.5 Energy Saving Setting

Deep Standby After: Set the time period during which the receiver will switch from standby mode to

Off mode. The receiver consumes less power in standby mode than in On mode.

It consumes even less power in deep sleep mode, but it takes about 30 seconds

to power on from deep sleep mode.

Auto Standby After: Set the time period after which the receiver shall automatically switch to standby

mode, if no input signal is detected during that period.

This is the additional way of reducing the energy consumption of the receiver.

6.2.6 Parental Control

The Parental Control function mostly depends on information broadcasted by operator and channels. The

operator can set age restrictions for programmes according to the legislation of the country where the

broadcast takes place.

You can also change the PIN code of the receiver in this menu. Enter the current PIN code, then the new

PIN code and confirm the new PIN code.

6.2.7 Factory default

For user convenience, the receiver provides the function reset to factory settings. In this menu, the PIN

code and all settings, channels and lists are reset to the factory settings.

DEFAULT PIN CODE: 0000.

Also, the PIN code of the receiver is reset to the factory setting: 0000. If necessary, change the PIN code in

the Parental Control menu. See section 6.2.6 Parental Control.

6.3 Timer & Update

6.3.1 Timers

Use the timer function to switch the receiver on according to the defined settings.

6.3.2 Software update via USB

Follow the instructions for the software update carefully in order to update the software on an USB storage

device.

NOTE:

• Please wait until the software update is completed. Avoid any actions until the update process is finished

or an error message appears.

• Do not unplug the receiver from the mains until the software update is completed.

• Do not disconnect the USB storage device from the receiver until the software update is completed.

Failure to follow the above instructions can lead to receiver failure and as a result the warranty will void.

6.3.3 OTA Update

From time to time software updates might be necessary when the receiver is in operation mode. This

depends on continuous improvements of the receiver functions, removal of detected defects and safety

protection of the Conditional access system.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Thomson THT700 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Thomson THT700

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info