Bedienungsanleitung Toolland TC78020 (Seite 4 von 16) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

622276

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

TC78020

V. 01 – 15/06/2015 4 ©Velleman nv

5. Overview

Refer to the illustrations on page 2 of this manual.

indicator light

heating positions

thermostat

handle

6. Installing the Device

 Install the device at a minimal distance of 50 cm of flammable objects, walls or buildings. Make sure the air

intake and output of the device are always free and unobstructed.

 Do not use the device in a room containing a bathtub or shower cubicle, or near a pool, washbasin or water

tap.

 Never place the device on an irregular or unstable surface (e.g. a bed) to prevent the device from tipping

over.

 Do not install the device directly below a mains outlet.

7. Power Cable

 Uncoil the power cable in a way that no one can trip over it or stand on it. Only use extension cords which

are compatible with the device's power and which are tested according to the VDE standards.

 Make sure the power cord does not come in contact with any part of the device.

 Never pull the cord to pull the plug from the mains outlet. Never transport or move the device by pulling

the power cord.

 Do not wind the power cord around the device.

 Do not use the device with an unwound power cord.

 Do not attach the power cord with sharp objects or pull over corners. Do not lay the power cord onto hot

cooking plates, in or over an open fire.

8. Operation

 Turn the switch in the desired position and turn the thermostat to its maximum position. The device will

now heat until the desired temperature has been reached.

 Next, turn the thermostat to the left until the heater switches off. The device will now automatically switch

on and off to keep the desired temperature.

9. Overheating Protection

This device features an overheating protection and will automatically switch off when the device's temperature

runs too high. If this is the case, disconnect the device from the mains and leave to cool down for 10 minutes.

Reconnect to the mains and use the device as described above. Please contact your dealer if the device keeps

switching off.

10. Cleaning and Maintenance

 Pull the plug from the mains and leave the device to cool down completely before starting cleaning.

 Never clean the device with water and do not immerse it in any liquid.

 Wipe the housing with a moist, lint-free cloth.

11. Technical Specifications

power supply

230 VAC, 50 Hz

power consumption

2000 W

Use this device with original accessories only. Velleman nv cannot be held responsible in the event

of damage or injury resulting from (incorrect) use of this device. For more info concerning this

product and the latest version of this manual, please visit our website www.toolland.eu. The

information in this manual is subject to change without prior notice.

The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this

manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the

prior written consent of the copyright holder.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toolland TC78020 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info