Bedienungsanleitung Topcom Twintalker 5400 - RC 6403 (Seite 4 von 52) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

483956

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Twintalker 5400

10 Description

See folded cover page - illustration 1

1. Antenna

2. LCD display

3. Optional headset connector

4. Optional charger connector

5. On/Off- / Menu key

6. Speaker volume up

7. Speaker volume down

8. Microphone

9. Speaker

10. Call / Key lock key

11. Channel down

12. Channel up

13. Monitor key MON

14. PTT-key

11 LCD display information

See folded cover page - illustration 2

15. RX icon

16. Battery level indication

17. TX icon

18. Keylock icon

19. Volume icon

20. Vox icon

21. Channel indication

22. Sub channel indication

23. Scan icon

24. Call icon

12 Using the Twintalker 5400

12.1 Turning the Unit ON/OFF

12.2 Battery Charge Level / Low Battery Indication

The battery charge level is indicated by the battery icon on the LCD Screen.

Battery full

Battery low

Battery almost empty

12.3 Adjusting Speaker Volume

There are 8 speaker volume levels (0..7)

12.4 Receiving a signal

The unit is continuously in the receive mode when the unit is switched ON and not transmitting.

12.5 Transmitting a signal

12.6 Changing channels

12.7 Sub -channels : CTCSS (Continious Tone Coded Squelch System) /

DCS (Digital Coded Squelch)

License free PMR radio's operating on the 446 MHz frequency band, have 8 available radio channels. If there are many PMR users

in your neighborhood, there is a chance that some of these users are operating on the same radio channel.

To prevent that you receive signals from other users, sub-channels have been integrated.

Two PMR radio's will only be able to communicate with each other when they are operating on the same radio channel and when they

have selected exactly the same sub-channel.

There are two kind of sub-channels :

• Continuous Tone Coded Squelch System (CTCSS)

• Digital Coded Squelch (DCS)

When using CTCSS, a low frequency tone (between 67 and 250 Hz) will be transmitted along with the voice signal. There are 38

available tones to choose from. You are free to choose one of these 38 available tones. Due to filtering, these tones will generally not

be audible so they will not disturb the communication.

DCS is similar to CTCSS, but instead of sending a continuous tone of a selected frequency, a digital data transmission is added to the

radio signal. This Digital Code is transmitted at a really low rate, around 134 bits per second (the code is 23 bits long). Only the PMR's

of the latest generation will support DCS. There are 83 available DCS codes that can be used. Since earlier models will only support

CTCSS it will be better to use DCS to prevent that other users will be audible during your PMR conversations.

To turn ON:

• Press and hold the - key for 2 seconds. The unit will “beep” and the LCD

display will display the current channel.

To switch OFF:

• Press and hold the - key for 2 seconds. The unit will “beep” and the LCD

display will turn blank.

Do not short-circuit the batteries or dispose in fire. Remove the batteries if this device is not going to

be used for a long period.

Do not charge non rechargeable batteries like Alkaline batteries in the charger. This might damage the

PMR’s and charger unit.

If the segments and icons of the displays are shown in light grey in this user guide, it indicates

that they are blinking.

• Press the - key in stand-by-mode to increase the speaker volume. The

volume level is displayed.

• Press the - key to decrease the speaker volume.

• After 5 seconds, the unit will go back to idle status.

• Press and hold the PTT - key to transmit. The TX symbol is displayed.

• Hold the unit in a vertical position with the microphone 10cm from the mouth and

speak into the microphone .

• Release the PTT - key when you want to stop transmitting.

• Use the - key or the - key to go to a higher or lower

channel.

• Press the PTT - key to confirm

When the battery is almost empty, the unit will turn OFF automatically after 30 seconds.

In order for other people to receive your transmission, they must also be on the same channel and have

set the same sub-channel (Chapter 12.6 and 12.7).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Topcom Twintalker 5400 - RC 6403 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info