Bedienungsanleitung Torqeedo Cruise 3.0 FP (Seite 74 von 92) (Deutsch, Englisch)

807535

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

DE EN

If you are unable to successfully complete the system test despite checking all

points, contact your dealer support or Torqeedo Service.

7 Commissioning

7.1 Settings

7.1.1 Setting the battery type and units of measurement

The battery types and units of measurement are set via the on-board computer

on all Torqeedo systems. The information required to set the battery type and the

units of measurement can be found in the operating manual for the respective

accelerator lever.

Notes on setting the battery type

When using external batteries, note that you are specifying the actual usable

capacity of your battery bank.

TIP! If you use external batteries and a battery monitor (not included), you can

adjust the age-related capacity change of your battery bank once per season. To

do this, charge the empty battery bank to 100 %. Read the charged ampere hours

(Ah) on the battery monitor and correct the original value in the system.

You can choose from the following units of measurement:

Range Kilometre (km)

American miles (mi)

Nautical miles (nm)

Hours (h)

Speed Kilometres per hour (km/h)

Miles per hour (mi/h)

Knots (kn)

Battery state of charge display (SOC) Percent (%)

NOTE! When setting the battery bank size, note that, for example, a battery

bank with 2 serially connected batteries of 12 volts and 200 Ah each has a total

capacity of 200 Ah at 24 volts (and not 400 Ah).

7.1.2 Enumerating the battery (Cruise 3.0 FP only)

To set up communication between the battery and the outboard motor, the bat-

teries must be registered once with the system.

The corresponding information for enumerating of the batteries can be found in

the operating manual for the respective accelerator lever.

NOTE! When using the Cruise system with a different battery bank, the enumera-

tion must be carried out again.

7.1.3 Setting forwards/reverse motion

You can adjust the direction of accelerator lever rotation for forwards/reverse

motion according to your needs. The corresponding information can be found in

the operating manual for the respective accelerator lever.

8 Operation

WARNING

Danger to life due to boat not being manoeuvrable! This can result in moder-

ate or severe bodily injuries.

• Find out about the intended travel area before you set off and observe

the forecast weather and sea conditions.

• Depending on the size of the boat, always have the necessary safety

equipment ready (anchor, paddle, means of communication, auxiliary

drive if necessary).

• Check the system for mechanical damage before starting to drive.

• Only drive with a system that is in perfect working order.

8.1 Operation in emergency situations

You can stop your Torqeedo motor in several ways in an emergency. The system

has appropriate safety features for this purpose. Depending on the conguration,

the system has either an emergency stop magnetic chip or a kill switch cord with

switch or an emergency kill switch.

Please note that the type of stop impacts the restart.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Torqeedo Cruise 3.0 FP Seite 74

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Torqeedo Cruise 3.0 FP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info