1-41
Cause
zThe power cord is disconnected
zDVD or VCR button is not switched
properly.
zNo disc is inserted.
zNo tape is inserted.
zThe TV is not set to receive DVD+VCR
signal output.
zThe video cable is not connected
securely.
zThe Progressive Scan is set to On on
the setup menu but is connected to a
standard(analog) television.
zThe equipment connected with the
audio cable is not set to receive
DVD+VCR signal output.
zThe audio cables are not connected
securely.
zThe power of the equipment connected
with the audio cable is turned off.
zThe Digital Audio Output is set to the
wrong position.
zThe disc is dirty.
zThe TV channels are not tuned in properly
zTape heads are dirty.
zTape is a rental or was recorded on
another VCR.
zThis unit can only output 625p
Progressive scan picture.
zAn unplayable disc is inserted.
zThe disc is placed upside down.
zThe disc is not placed within the guide.
zThe disc is dirty.
zThe Rating level is set.
zIs the cassette compartment empty?
zAudio mode is not set properly.
zNICAM mode is not set properly.
Correction
zPlug the power cord into the wall outlet
securely.
zRefer to page 6.
zInsert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
zSelect the appropriate video input mode
on the TV so the picture from the
DVD+VCR player appears on the TV
screen.
zConnect the video cable into the jacks
securely.
zSet Progressive Scan to Off
(see page 19).
zSelect the correct input mode of the
audio receiver so you can listen to the
sound from the DVD+VCR player.
zConnect the audio cable into the jacks
securely.
zTurn on the equipment connected with
the audio cable.
zSet the Digital Audio Output to the
correct position, then turn on the
DVD+VCR player again by pressing
++//11.
zClean the disc.
zCheck tuning, carry out tuning again.
zClean video heads.
zUse PR/TRK (+/-) for manual tracking
adjustment while tape is playing.
zMake sure that your TV can support
625p Progressive scan picture or set
Progressive scan to off.
zInsert a playable disc. (Check the disc
type and Regional code.)
zPlace the disc with the playback side
down.
zPlace the disc on the disc tray correctly
inside the guide.
zClean the disc.
zCancel the Rating function or change
the rating level.
zEject the tape in.
zSelect STEREO by repeatedly pressing
AUDIO on the remote control.
zMake sure NICAM in the menu is set to
AUTO for the station to be recorded.
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power.
The power is on, but
the DVD+VCR player
does not work.
No picture.
No sound.
The playback picture is
poor.
The DVD+VCR player
does not start playback.
Video tape cannot be
inserted.
No Hi-Fi sound
No NICAM sound
recording
