Bedienungsanleitung Toshiba TLP-T50 (Seite 9 von 20) (Englisch)

485565

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Preparations

Placement Styles

As shown in the figures below, this device can be placed in 4 different styles.

The factory setting is “floor-mounted front projection.” Set the placement style in the

default setting menu

p.28

, in accordance with your needs.

Projection Distance and Screen Size

Use the figures, table, and formula below to determine the screen size and projection

distance. (Screen sizes are approximate values for full-size picture and no keystone

adjustment)

Placement

Floor-mounted front projection

Floor-mounted rear projection

Ceiling-mounted front projection

Ceiling-mounted rear projection

CAUTION

• Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when

placing the unit.

• If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so.

Mounting the projector on a ceiling requires special ceiling brackets (sold separately)

and specialized knowledge. Improper mounting could cause the projector to fall,

resulting in an accident.

a is the distance (m) between the lens and

the screen, and corresponds to a range of

1.41 m to 11.45 m.

Screen

As seen from above

Lens center

As seen from the side

screen

projection distance a(m)

min length max length

size (cm)

(zooming max) (zooming min)

32 (81) — 1.41

40(102) 1.49 1.79

60(152) 2.26 2.70

80(203) 3.02 3.62

100(254) 3.79 4.53

150(381) 5.70 6.82

200(508) 7.62 9.11

250(635) 9.53 11.40

300(762) 11.45 —

AC IN

a (min length) =

projection size (inches) – 1.082

26.107

a (max length) =

projection size (inches) – 0.906

21.854

■

Operating the remote control

Point the remote control toward the

projector’s infrared remote sensor,

and press a button on the remote

control.

• Operating the projector from the front

Approx. 15°

Approx. 5m

• Operating the projector from the rear

Approx. 15°

Approx. 5m

■ Loading dry-cell batteries

into the remote control

q Remove the battery cover.

w Insert the dry-cell batteries.

Be sure to align the plus and minus

ends of the batteries properly.

Two batteries (LR03 or R03, SIZE

AAA) are used.

e Replace the battery cover.

Dry-cell batteries

• Remove batteries from remote control when not using for extended periods.

• If the remote control stops working, or if its range decreases, replace all the batteries

with new ones.

The remote control

• The remote control may fail to operate if the infrared remote sensor is exposed to bright

sunlight or fluorescent lighting.

• Do not drop or bang.

• Do not leave in hot or humid locations.

• Do not get wet or place on top of wet objects.

• Do not take apart.

• In rare cases, ambient conditions could impede the operation of the remote control. If

this happens, point the remote control at the main unit again, and repeat the operation.

Preparing and using the remote control

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba TLP-T50 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info