The default setting menu
This menu shows placement status and other settings.
Default setting 1 menu
Item
Description
Auto keystone Always corrects keystone distortion automatically. On Off
No signal
power off
Sets the time to wait for the power to be turned off after the last operation is
made with no input signal.
On (not turned off)
30 min.
Auto input
search
Sets whether the input with signals is only selected or not. On Off
Network input
detection
Sets how to detect the Network input when Auto input search is [On].
Always Normal
Beep
Beeps when operation is made. On Off
Voice guide Informs the operation status and abnormal conditions.
Off
Small Loud
Power on Sets whether to turn on the power when the ON/STANDBY button is pressed
(Manual), or when the power cord is plugged in (Auto).
Manual
Auto
Network standby
Switches on/off the network while the projector is in standby. On Off
Lamp power
Sets the lamp power.
Low
Standard
Detailed description
[Auto input search]
[On]: Automatically searches the signals that can be
projected, and switches input from the connected
device that outputs the video signals each
time the INPUT button is pressed. Input from a
connected device that outputs no video signals
is skipped.
[Off]: Displa
ys the Input select menu.
Toggle with
buttons and press button.
(The input without signals can be also selected.)
Note
In normal operation, set [Auto input search] to [On].
Set to [Off] when you want to select the input
source from Input select menu, or if the image does not appear properly.
[Network input detection]
If [Always] is set, even while no images are sent to the projector through the Network
input, the Network input will be selected when the Auto input search is [On].
If [Normal] is set, the Network input is selected only while images are being sent to
the projector through the Network input.
Note
It is recommend that you set the [Network input detection] to [Normal] as long as
you do not use the Network input.
■
•
•
Input select menu
Using the menus 1 (Continued)
[Power on]
If [Power on] is set to [Auto] and there is a power outage, the projector will come on
once power is restored.
[Network standby]
When [Network standby] is set to [On], the network is switched to the standby state as
the projector enters standby. While the network is in standby, the projector can be powered
on using the remote control function of the Network Utility. When [Network standby] is
set to [Off], the projector cannot be powered on with the remote control function of the
Network Utility.
[Lamp power]
When [Lamp power] is set to [Low], the screen becomes a little darker, but the cooling
fan noise gets quieter.
Default setting 2 menu
Item
Description
Projection
mode
Sets projection mode in accordance with Placement Style.
(Standard)
(Rear)
(Ceiling)
(Rear ceiling)
Fan mode Sets the cooling fan speed. Standard
High
Remote control When 2 projectors are used and controlled by the remote control respectively,
this menu sets the code for the projector and the remote control.
[
or : Enter setting] [
: Select from 1, 2
] [ : Confirm]
[
:Select OK to end
]
Press [Cancel] to return.
Key lock Lock the control panel buttons.
[
or : Enter setting] [
: Select On/Off
] [ : Confirm]
[
:Select OK to end
]
Press [Cancel] to return.
Closed Caption Closed Caption settings.
Press
or and switch with and .
Off/ CC1/ CC2/CC3/CC4/T1/T2/T3/T4
Reset all
Press
. (The password and user logo are not reset.)
Resets all adjustments and settings to their factory settings. Yes
No
Password
Password setting
