798767
8
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
SECTION ONE: ASSEMBLY INSTRUCTIONS
INSTALLING THE AXLE: (Refer to the COM200 AXLE MOUNTING diagram)
Raise one side of the COM200 Grill Body (32) approximately 6 inches and securely
block in place. Repeat with the opposite side. This should provide you with enough
room to slide the Axle (38) into place and bolt the Axle Mounting Bracket on Axle (39) to
the Axle Mounting Bracket on Grill (37). Bolt in place using the 1/2” x 2” Bolts (40),
Washers (41), Lock washers (42) and Nuts (43) as shown in the Axle Mounting
diagram. MAKE SURE ALL 4 BOLTS ARE TIGHT.
MOUNTING THE WHEELS:
Using the same procedure as above, securely block each side of the Grill Body (32) and
then bolt the Wheels (31) on to the Axle (38) with the Lug Nuts provided. MAKE SURE
ALL LUG NUTS ARE TIGHT.
INSTALLING THE TRAILER TONGUE:
Thread the wiring through the Trailer Tongue (21). Carefully slide the Trailer Tongue
(21) into the Trailer Tongue Receiver (30), being careful not to damage the wiring. Align
the two holes in the Trailer Tongue (21) with the two holes in the Trailer Tongue
Receiver (30). Insert a 1/2” x 4 1/2” Bolt (22) with Flat Washer into each hole and install
Flat washer, Lock washer and Nut. MAKE SURE 2 BOLTS ARE TIGHT. Attach the
white ground wire, with the ring connector, to the hex screw installed below the Trailer
2” Ball Hitch (23).
ATTACHING THE FENDERS:
The Fenders [Left and Right] (18) mount over each Wheel (31). Make sure that the
Trailer Lights (19) are facing toward the Roll-up Door (14). There are four nut inserts
(Nut Serts) installed on each side of the Grill Body (32). Line up the holes in the Fender
(18) with the Nut Serts. Insert one of the 1/4" Bolts with a Flat Washer (27) into each
Fender hole and bolt into place. Do not over tighten. Connect the Trailer Wiring to the
Trailer Lights (19). On the Left Trailer Light (19) connect the Yellow Wire (29) from the
Trailer to the Red Wire (28) from the Light. Connect the remaining two wires. On the
Right Trailer Light (19), connect the Green Wire (29) from the Trailer to the Red Wire
(28) from the Light. Connect the remaining two wires.
REMOVING THE COM200 FROM THE PALLET:
Put a board under each wheel and carefully roll the COM200 off the end of the pallet.
Use the Trailer Tongue (21) to steer the Grill. Put the Jack Stand (24) down to help you
move the Grill.
NOTE: IF AT THIS POINT YOU ARE READY TO START YOUR GRILL, REFER TO
THE INITIAL FIRING INSTRUCTIONS IN SECTION TWO OF THIS MANUAL OR ON
A SEPARATE SHEET IN THE PELLET HOPPER, BEFORE PROCEDING WITH
FURTHER ASSEMBLY.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Traeger COM200 - Large Commercial Trailer wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info