Bedienungsanleitung Traeger Renegade Pro - TFB38TOD (Seite 21 von 24) (Englisch)

798756

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

traegergrills.com

Question Answer

Why does my grill

re go out on

SMOKE setting?

There may be excess ash in the repot which needs to be cleaned.

WARNING! If the re in the repot

goes out while smoking and there

are sufcient pellets in the pellet

hopper, it is important to complete

the following instructions. Failure to

do so may cause a hazardous “over-

ring” of your grill due to an excess

of unburned pellets in the repot.

DANGER! Turn the switch OFF (O) and

disconnect the power cord. Allow the grill to cool

thoroughly. Open the door and remove all food,

the porcelain-coated grill grate, the grease drain

pan, and the heat shield.

WARNING! Remove all unburned pellets

and ash from inside and around the repot.

(See instructions for proper handling and

disposal of ash in on page 19.)

Before replacing the heat shield, grease drain

pan, and porcelain-coated grill grate, plug

the power cord into the appropriate grounded

electrical outlet and turn the switch ON (I).

Pellets should fall into the repot and the hot

rod should begin to heat (it will start to turn

red). CAUTION! Do not touch the hot rod.

When ames start to come out of the repot,

turn the switch OFF (O). Let the grill cool down.

Now you’re ready to place the heat shield, grease

drain pan, and porcelain-coated grill grate back

into the grill. With the door closed, turn the

switch ON (I) and turn the temperature dial to

SMOKE. In about 2 minutes, the pellets will

ignite and whitish-gray smoke will come out of

the grill. After the pellets have ignited, turn the

temperature dial to any cooking setting desired.

If this does not x the problem, contact

Traeger's VIP-365 Customer Service

(see page 26) for assistance.

With the Traeger

Digital Pro

Controller, what

dial setting is

recommended for

starting the grill?

The auto-start procedure is the same for all grill controls. With the door closed, turn

the switch ON (I) and turn the temperature dial to SMOKE. In about 2 minutes, the

pellets will ignite and whitish-gray smoke will come out of the grill. After the pellets

have ignited, turn the temperature dial to any cooking setting desired.

How do I protect

my paint nish?

Use the protective cover on the grill and touch-up paint to repair any scratches.

Touch-up paint is available from your Traeger dealer, or log onto our website,

traegergrills.com.

Every 90 days, use a high-quality car wax on the outside surfaces of the grill.

ONLY APPLY WAX TO A COLD GRILL.

Where can I get a

new part for my

grill?

Check with your Traeger dealer. They

may have the part in stock or can

order the part for you.

In either case, please provide your name, phone

number, address, model, and serial number of

the grill (located on the label inside the hopper

lid), along with the part identication number

from the component diagram or parts list.

Contact Traeger's VIP-365 Customer

Service (see page 26) to place an

order.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Traeger Renegade Pro - TFB38TOD Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info