Bedienungsanleitung Traeger Select Pro - BBQ400.03 (Seite 7 von 18) (Englisch)

798690

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

3) Remove the Porcelain Grills, Grease Drain Pan and Heat Baffle to expose the Firepot

In the bottom of the Grill.

4) Pour 1/2 cup of TRAEGER BBQ PELLETS into the Firepot.

5) Squirt 2 tablespoons of Alcohol Gel fire lighter into the Firepot on top of the Pellets.

DANGER! Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter

fluid or similar liquids to start or “freshen up” a fire in this Grill. Keep all such liquids

well away from the Grill when in use.

6) Carefully light the Alcohol Gel with a fireplace match or a long-reach butane lighter.

DANGER! Never squirt Alcohol Gel into a burning fire or a hot Firepot. The Alcohol

Gel bottle could explode and cause a fire, serious injury or death.

7) Let the Alcohol Gel and Pellets burn for approximately 4 minutes.

8) After assuring the Pellets have ignited, install the Heat Baffle, Grease Drain Pan and

Porcelain Grills back in place.

CAUTION! You will now have a fire in the Firepot. Be careful not to burn yourself

when you install these components. Gloves are recommended.

9) Turn the Switch ON (--) and the Temperature/Dial to any setting desired. With the

Door closed, let the Grill pre-heat for approximately 10 minutes before placing food in

the Grill.

Control Shutdown cycle

The control for this barbecue comes with an automatic shut down cycle. When

finished cooking on your barbecue set the Temperature/Dial Knob to the Shutdown

Cycle position, this will leave the Draft Induction Fan running for ten minutes to burn any

excess pellets in the fire pot. After the fan runs for ten minutes the controller will power

off and the fan and it will stop running. CAUTION! The main power switch will shut the

power off to the controller and the Temperature/Dial Knob switch will cut off power to

the grill components only. When servicing the controller or any parts ensure that the

power supply is disconnected to avoid a shock hazard.

Control Safety Features

The controller comes equipped with 2 safety features that will help you to keep

the grill operating correctly. The first of these is a low temperature alarm. If the grill

stays below 125 degrees as read by the RTD temperature sensing device for a period

of 10 minutes the control will go into an alarm state and the display will read “LEr”. This

will shut off all power to the internal components of the grill. The display will stay in this

state until you turn off the main power switch.

The second safety feature will be a high temperature alarm. If the grill obtains an

internal temperature reading of 550 degrees as read by the RTD temperature sensing

device the control will go into alarm state and the display will read “HEr”. This will turn

off all power to the internal components of the grill. The display will stay in this state until

you turn off the main power switch.

Whenever either of these alarm conditions occurs you should check to see what

caused this condition and fix the problem. Call customer service if you need help.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Traeger Select Pro - BBQ400.03 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info