Bedienungsanleitung Tristar KB-7146 (Seite 4 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

530932

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

* Competent qualified repair service: after sales department of the producer

or importer or any person who is qualified, approved and competent to

perform this kind of repairs in order to avoid all danger. In any case you

should return the appliance to this repair service.

IMPORTANT

• Read the operating instructions carefully in order to get to know the

equipment before putting it into operation.

• Keep the instructions for future reference.

INSTALLATION OF THE APPLIANCE

• Install the appliance on a firm, horizontal surface. To level the

appliance, use a spirit level or a vessel containing water, if necessary.

• Avoid installing the appliance in direct sunlight or near any source of heat.

• The distance between the rear of the appliance and a wall shall not be

less than 10 cm, and the minimum ventilating space from the sides of

the appliance shall never be less than 5 cm.

• In all cases, the location shall be protected from rain and splashing.

• To guarantee a good level of air circulation, do not obstruct the

ventilation grids of the upper, lower or rear surface of the appliance.

• Complying with the above will ensure efficient and economical cooling.

• Before the first use of the appliance, clean the inside and the cover of

the appliance with warm water, adding detergent if necessary. Never

use an abrasive product.

OPERATION WITH THE MAINS 220  240 V

• Never use another source of energy at the same time (battery, gas).

• Check that the mains voltage corresponds to the operating voltage

specified on the label (on the rear of the appliance).

• If the electrical specifications are correct, push the safety electrical plug

into an earthed wall socket which is wired according to the specifications.

STARTUP

• Turn the thermostat knob clockwise to the MAX position. The effects of

the cooling process (frost on the evaporator) only become visible after

about an hour.

• The thermostat enables the temperature of the cool box to be

adjustable (“0”=cooling process stopped).

• After a sufficient cooling period (approximately 5 hours), the

thermostat can be set to an intermediate position. The selected

temperature is regulated automatically by the thermostat.

Shut-down

• Turn the thermostat knob anti-clockwise to the “0” position.

• Remove the plug from the wall outlet.

OPERATION WITH A BATTERY 12V

• Do not use another source of energy at the same time (mains, gas).

• A safety fuse must be installed in the power supply line between the

battery and the cool box. For 12V, the maximum fuse rating is 6,25 A.

Cable cross-section Max. cable length

2.5 mm

2.5 m

4.0 mm

4.0 m

6.0 mm

6.0 m

• It is not necessary to check the polarity when starting up the appliance.

• Check that the battery voltage corresponds to the operating voltage of

the cool box, as marked on the corresponding the label.

Instruction manual

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tristar KB-7146 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info