Bedienungsanleitung Tristar KB-7146 (Seite 6 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

530932

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

• When changing the gas cylinder and/or disconnecting the hose, it is

mandatory to close the valve of the gas cylinder.

• Replace the hose if it is damaged or if it becomes porous and in any

case before the expiry date printed on the side.

GAS VALVE ASSEMBLY

• This assembly consists of an adjusting device with an incorporated

safety pilot, a burner with an electric igniter.

• The adjusting device can be set to 3 different positions:

Max Maximum cooling

MIN Minimum cooling

0 off Igniting position / burner gas supply closed

• The safety pilot automatically maintains the gas supply to the burner, as long

as it remains lit. It automatically shuts off the supply if the flame goes out.

IGNITION OF THE GAS BURNER

• Open the valve of the gas cylinder. Press the adjusting knob and hold it

in this position, then turn the knob anti-clockwise to Max.

• If the appliance has not been ignited for a long period, or if the gas

cylinder has been changed, there may be some air in the duct, so it

may fail to be ignited. It is necessary to check that the pilot is lit by

looking through the orifice at the top of the appliance. If the appliance

fails to be ignited, try it again after approximate 10 seconds.

• When the outside temperature is low, set the adjusting device to MIN

after a sufficient long cool-down period in MAX position.

To disconnect an appliance running on gas far from any source of ignition

• Shut off the gas cylinder or the pressure regulator. Turn the knob to the

OFF position.

Storing food

• Liquids to be stored in cool box shall always be placed in a closed vessel.

• The air circulation inside the appliance must not be obstructed.

Never place hot food or drink in the appliance. Never keep ammable

liquids and/or gases inside the cool box. Danger of explosion.

DEFROSTING  MEASURES TO BE TAKEN IF THE

APPLIANCE IS TO BE LEFT UNUSED FOR A LONG

PERIOD

The cool box must be defrosted regularly, in order to ensure that it

operates correctly. To defrost the cool box, disconnect it and remove all

food outside. If necessary, use a cloth soaked with hot water. After de-

icing, mop up the water with a dry clean cloth and clean the inside. If the

appliance is to remain unused for a extensive period, disconnect it and

remove all food outside. After de-icing, clean and dry the inside of the

appliance. In order to prevent unpleasant odor, leave the cover of the cool

box slightly open.

Measures to be taken after unused for a long period

If, after an extensive lay-up period, the cool box does not produce any

cooling, disconnect the appliance and turn it upside down for a few minutes

then turn it the right way up. After turn it over several times, reconnect it.

MAINTENANCE

• Clean the appliance regularly with warm water, containing a detergent

if necessary.

• Never use an abrasive product. Dry the cleaned surfaces with a soft cloth.

• Use only clear water to clean the seal of the cover, and then coat the

seal with talcum powder.

Instruction manual

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tristar KB-7146 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info