Bedienungsanleitung Tronic KH 3033 (Seite 9 von 13) (Englisch)

464874

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

10 GB/IE/CY

Operation

Reset / deleting settings

After connection to the power supply, the appliance

automatically returns to its basic setting and remains

in STANDBY mode

Switching between modes 1,

2, 3 and 4

j Press the MODE selection button

the appro-

priate number of times.

The device switches between charging modes in

the following order: Standby

, MODE 1

„6 V“, MODE 2

, MODE 3 , MODE 4

and then repeats the cycle

NOTE: If you press the selector button

, charging

mode automatically switches over to the next mode

and begins operation in that mode.

NOTE: However, if a battery is not disconnected

from the charging station after a full charge, the

appliance remains in trickle-charge mode, even if

the user switches over to another mode. This pro-

tects the battery from being damaged.

Mode 1 „6 V“ (7.3 V / 0.8 A)

This mode is suitable for charging 6 V lead-acid

batteries with a capacity less than 14 Ah.

j Press the selection button MODE

, to select

mode 1. After doing so, the corresponding LED

display „6 V“

lights up. If you do not activate

an-other process afterwards, the electronic sys-

tem will automatically start the charging process

together with the LED display

at (with a

current of) 0.8 A ± 10 %. If the procedure runs

without any problems, the LED display

remains on during the entire charging proc

ess,

un-

til the battery is fully charged at 7.3 V / ±

0.25 V.

When the battery is fully charged, LED display

lights up and LED display

goes

out. The device now switches automatically into

maintenance charging mode.

Mode 2 „12 V“ (14.4 V / 0.8 A)

This mode is suitable for charging 12 V lead-acid

batteries with a capacity less than 14 Ah.

j Press the selection button MODE

, to activate

mode 2. After completion of this process, the

appropriate LED indicator

lights up.

Then if you do not take any further action, the

electronic control and the LED indicator

automatically switches on and starts the charg-

ing process. If the procedure runs without any

problems, the LED display

remains on

during the entire charging process, until the

battery is fully charged. When the battery is

fully charged, LED display

lights up and

LED display

goes out. The device now

switches automatically into maintenance charg-

ing mode.

Mode 3 „12 V“ (14.4 V / 3.6 A)

This mode is mainly suitable for charging 12 V

lead-acid batteries with a capacity greater than

14 Ah under normal conditions.

j Press the selection button MODE

, to activate

mode 3. Then if you do not take any further ac-

tion, the electronic control and the LED indicator

switches on and starts the charging

process. If the process runs without any problems,

the LED indicator

remains on during the

whole charging process until the battery is

charged. When the battery is fully charged, the

LED indicator

and the die LED indicator

go out. The device now switches auto-

matically into maintenance charging mode.

Mode 4 “12 V” (14.7 V / 3.8 A)

This mode is used for charging 12 V lead-acid bat-

teries with a capacity greater than 14 Ah under

cold conditions or for charging some AGM (Absorb-

ent Glass Mat) batteries with a capacity greater

than 14 Ah.

33211_Battery charger_Content_LB6.indd 10 24.06.09 10:30

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tronic KH 3033 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Tronic KH 3033

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info